Search results

Those speeds are pretty impressive.

I think I've seen RL16 being used here, but that stuff is rare and expensive! VV N555 might work if not too bulky or slow burning.

This made me look at the post again and see the error in my ways. Thanks!

I don't see any unsupported case in post 6964. I can see the extraction groove cut as well a a reflection of the case.

Standard bushing or shoulder bushing version?

Have them for single pulls?

What reamer was used to cut the chamber?

Are you talking about the area between the trigger and mag well opening? If so I called ARC and they said that the DLC coating has worn and not to worry about it. If that’s not what you are talking about forget everything I said. 😎

Use the same start data as the 107s. All the QL data I’ve gotten from Berger has been very conservative.

Paid

I’ll take it.

Bore to case capacity ratio. Basically the same case volume, less volume in a 22 bore than a 243 bore. Over bore cartridges are harder on barrels.

I’m pretty sure SAC has a taper to the first part of their bushing. Basically it only fully sizes about half the neck. I don’t remember who, but think Wilson does the same thing. They say flip it over if you want more of the neck sized.

Gotcha. For some reason I thought you were using their complete die.

@drglock It could be a slight difference in neck tension between the two dies? The sizing could be slightly different resulting in a case capacity difference. I bet slight tweaking would result in groups of equal size. If not you could go back to the other sizer and live happily ever after.

What speed. How is case capacity and what brand case?

I’ve been waiting on a folder and a weight kit from AP before buying one. Still haven’t heard any rumblings of a weight kit.

Have you modded the cheek riser like the picture above?

This what I have said I would do if I bought a Solus Chassis! Do any parts fall out or get out of place when you pull the assembly out?

Got a pic of the modded piece?