TriggerCam 2.1 Clamping Screw Size?

[KnowNothing256]

Anybody happen to know what the clamping screw size is on the TriggerCam 2.1? Need thread diameter/pitch and screw length, if anyone can help a guy out

 

[Mike Casselton]

Ace Hardware is your best bet. 5 minutes and you're in and out.

 

[iceng]

Ill check in thr morning, but at a guess, im gonna say M3 or M4. Not imperial.

 

[Cynical]

Anybody happen to know what the clamping screw size is on the TriggerCam 2.1? Need thread diameter/pitch and screw length, if anyone can help a guy out

definitely not m4. By thread pitch it should be m3x.5, 10mm thread length. https://www.mcmaster.com/91290A115/

Caveat: the smallest screw size I can measure by a thread checker is m4 and the Triggercam screw is small enough to be fully inserted without threading.

I measured the thread pitch at .5 metric on a screw gauge, which corresponds to m3 (m3x.5). The thread length is 10mm. I feel very confident about this size but wanted to tell you how I measured it. And caliper says it is a cunt hair under 3mm, so that checks out.

 

[KnowNothing256]

Thanks, I really appreciate the info!

 

[iceng]

M3x10mm long. Sorry for the delay, totally forgot.