Hi how's it going?
OK so I reload for my Remington 6mm now and when I load once fired brass there is no problem.
When I reload second time fired my bolt won't close shut. Unless I force it hard.
Here are my reloading steps:
Deprime and neck size then clean.
Chamfer primer pocket
Trim cases .003 below my throats Max.
Chamfer outside to inside of mouth.
Reprime cases.
Use my fl die set to bump shoulder back until my bolt will close.
My bolt won't close no matter how much I bump them. Even if I fl size my case.
I am incredibly stumped.
Its an rcbs fl die so idk if shoulder bumping with rcbs is possible?
OK so I reload for my Remington 6mm now and when I load once fired brass there is no problem.
When I reload second time fired my bolt won't close shut. Unless I force it hard.
Here are my reloading steps:
Deprime and neck size then clean.
Chamfer primer pocket
Trim cases .003 below my throats Max.
Chamfer outside to inside of mouth.
Reprime cases.
Use my fl die set to bump shoulder back until my bolt will close.
My bolt won't close no matter how much I bump them. Even if I fl size my case.
I am incredibly stumped.
Its an rcbs fl die so idk if shoulder bumping with rcbs is possible?