Just checked out the search bar--still works great, so bump for more info, por favor...
I'm looking into the Badger Micro FTE but can't find much feedback. Has anybody been using one for .308 with the crush washer? Got a diameter of the rear washer/barrel shoulder contact point? My barrel is @ .90" at the thread shoulder (22" Rock M24), and want to know if this brake is narrower back there. I would prefer to err on the side of wider than shoulder to protect the barrel edge. I can't tell if the above AR photo is .223 or .308... They make both, and Triad has em, so chime in if you can!
D_Lamz: Did you end up going this route?