Holy cow, what a nice tool. I am pissed off I waited so long to get this tool now. Set up takes two minutes, can do 20 cases per minute, with a twist after the cutting is done the trim is perfectly cut to length.
- Thread starter ArmyJerry
- Start date
Do they really work that well? Someone told me to look into one.
Got one for 223 and am going to get one for 308/243. I sure beats a hand trimmer..
Yes, just clean out the case bushing part ever couple hundred rounds. Get it you wont be sorry, I just used mine to trim a thousand cases of 308. will do 4 or 5 thousand 223 tomorrow.
Agreed, they are great for bulk reloading. I wouldn't shoot my AR's if I didnt have this bad boy!
WFT. True words. I use mine in a drill press. Awesome!
If Little Crow is listening... could you make a cutter that trims, chamfers, and de-burrs all in one step?
If Little Crow is listening... could you make a cutter that trims, chamfers, and de-burrs all in one step?
+1 on the trimmers. I bought 4 of them for every caliber I mainly shoot. They are ridiculously fast and accurate. I think I had +_ .001" difference at most. Plus the deburring aspect rocks
Use mine in a drill press for 308 (and all 308 based loads), 6.8 SPC, 223, and one more (forget which one it is). I do have to pull it from the press every now and again to empty the trimmer. If I used a hand drill (like the WFT was designed for), I do not think I would have to clean it out.
Great tool!!!
Great tool!!!
I've only used mine in 223 but I like it so much I bought one for 300blk.
Sent from my SGH-T769 using Tapatalk 2
Sent from my SGH-T769 using Tapatalk 2
great to hear more good things about this trimmer. I've been wanting to get one but have bit of difficulty justifying the $70 to trim just one cal. Granted right now I only shoot .223 and 6.5 creed.
Time is money. Trust us, it's worth every penny! Get one for whichever cartridge you reload more.
It forced my Wilson into semi-retirement.
What impressed me the most was the consistent trim length.
What impressed me the most was the consistent trim length.
Yeah unbelievable huh, I get a brush and brush out the bushing every 100 rounds or so, I also do a half twist when I feel the cutters stop cutting, I found this to leave the absolute smoothest edges and easier to chamfer, this thing is dead on accurate.
