Suppressors Form 1 big bore kits?

[coyotewillie]

Are there any form 1 kits that are stout enough for a 338 LM? I see people building kits and running up to 300 WM, but never larger. Not worried about putting my eye out, just blowing my face off.

 

[Longshot85]

The SD Tactical / solvent traps direct 12 inch long × 1.5 inch diameter should hold up

Call them, they are knowledgeable and will know for sure

 

[Longshot85]

My SD tactical 9 inch titanium tube currently has an aluminum end cap (have titanium replacement just haven't needed to use it yet) and it holds up to 6.5CM on my 26 inch barrel with hot hand loads moving a 147 ELD at 2860fps

 

[hlee]

My SD tactical 9 inch titanium tube currently has an aluminum end cap (have titanium replacement just haven't needed to use it yet) and it holds up to 6.5CM on my 26 inch barrel with hot hand loads moving a 147 ELD at 2860fps

Where did you source the internals? I don't see those parts on the SDTA site.

 

[Longshot85]

Where did you source the internals? I don't see those parts on the SDTA site.

Check out solvent traps direct

 

[Longshot85]

D size cups is what you want

 

[Geno C.]

Solventtrapsdirect don’t discuss form1 stuff with you. That’s coming straight from the owner. That being said, I have their 12” and I would think with a long enough barrel
And large enough blast chamber and probably their muzzle brake you would be good.