Gunsmithing Measurements on a tikka trigger.

[Dobbs02si]

I hate to start a thread on this, but I can't put my hands on one nor find the info. Does anyone have a tikka trigger group out they can measure? Pardon my ignorance as I don't know their terminology... What I'm looking for is the height of the catch for the striker that sits above the body. Set and released height would be nice, but I'll take the set height. This is for a non tikka project for those wondering. Thank you in advance.

 

[JGR1953]

Are you talking about the round pin that raises and blocks the sear and locks the bolt as you engage the safety ?
If so it measures roughly .1750 released/lowered and .4270 engaged/raised
If you need something else measured let me know.

 

[Dobbs02si]

I can use that as well. What I'm looking for is the hook behind it that releases the striker when tripped. It's the rear most feature closest to the safety lever.

 

[JGR1953]

I can use that as well. What I'm looking for is the hook behind it that releases the striker when tripped. It's the rear most feature closest to the safety lever.

What I get is .2215 as it sits
These measurements are probably +- a thousand or so.

 

[Dobbs02si]

I'm going to assume thats .2215? Caliper dims are plenty accurate. Thank you for the reply.

 

[Dobbs02si]

Can I bother you for one more number, the width of the housing not including pins, retainers or safety, just "the box"? Thank you again.

 

[JGR1953]

No probs it's .4305