6.5 PRC neck wall thickness (hornady)

[Maliclipse]

Hello,

Can someone measure the wall thickness on the neck of a Hornady 6.5PRC case?

If you also have an ADG case the wall thickness on that would be great too.

On that happy note does anyone know of a website that keeps a catalog of case staticsics?

Thanks!

 

[Jordanwickham]

Hello,

Can someone measure the wall thickness on the neck of a Hornady 6.5PRC case?

If you also have an ADG case the wall thickness on that would be great too.

On that happy note does anyone know of a website that keeps a catalog of case staticsics?

Thanks!

Not the same cases (PRC - CM) but since no one has responded with better I'll relate what I know about the CM cases. Hornady 6.5 CM runs average of .0125" as where Lapua and Alpha ( not ADG but still premium brass) ran L-.0135 and A-.014 (measured with a ball micrometer). As has been my experience with other cartridges Hornady is a thinner case and the premium brands run a little thicker. What do you need the neck thickness for? Turning necks , setting up a bushing, or just some other thing?

 

[Maliclipse]

I'm ordering a die and want to start with the appropriate bushing size. There must of been a run on the brass because I cant find hornady prc brass anywhere.

 

[Jordanwickham]

Do you have a loaded round in Hornady Brass?