RPR ambi safety

[erikc641]

What is everyone using for an ambi safety (if at all)? I tried installing a Seekins on my RPR with a Jard trigger and it wasn't having it. Ended up putting the stock one back in. It's a Gen2 6mm CM. FWIW the ambi was working until I put the lower bolts back in and tightened everything up.

 

[_Windrider_]

What is everyone using for an ambi safety (if at all)? I tried installing a Seekins on my RPR with a Jard trigger and it wasn't having it. Ended up putting the stock one back in. It's a Gen2 6mm CM. FWIW the ambi was working until I put the lower bolts back in and tightened everything up.

I never could get the seekins safety to work either. I’m going to try again when mine gets back from cerakote. I have a Timney trigger I’m going to install.

 

[erikc641]

So I tried another one, that is only 90*, and it went in no problem in less than 5 min

 

[unoigo]

Old thread but same issue here. The Seekins was a no go. Too mushing, false clicks, etc. what brand of standard 90 degree Ambi did you go with? @erikc641

 

[erikc641]

Old thread but same issue here. The Seekins was a no go. Too mushing, false clicks, etc. what brand of standard 90 degree Ambi did you go with? @erikc641

It was the AR Stoner 90* ambi from MidwayUSA. Not the prettiest, but it fits and works. I would bet that anything 90* only and milspec should work.

 

[unoigo]

Good info, thanks!