Gunsmithing Anyone in/near Jacksonville FL that can thread a barrel?

[plinkin]

Hey guys, I've got a mp15-22 that I want to thread the barrel on. Anyone near Jacksonville FL that can thread the end for a suppressor?

 

[Emmaandhaley]

OTM (exodus rifles) is right off the Phillips Hwy and the 295. (Be prepared to spend more money than you want because you will want/need something from OTM)

6694 Columbia Park Dr S.​

Jacksonville, FL. 32258​

 

[plinkin]

OTM (exodus rifles) is right off the Phillips Hwy and the 295. (Be prepared to spend more money than you want because you will want/need something from OTM)

6694 Columbia Park Dr S.​

Jacksonville, FL. 32258​

Thanks I was hoping someone might have a home lathe or something like that so I can keep the cost down a bit, I'll give them a call.

 

[TheBigCountry]

Exodus like has been said, or Wayne of Superior Gunsmithing does fantastic work.

 

[GONE BAD]

Another option is to reach out to S&W to see if you can get a replacement barrel that is threaded?
Mine came threaded from the factory.

Side note: I gave mine to one of my grandsons.
Every kid should have one

 

[LeftyJason]

Send it to LRI. They thread correctly and pretty quickly and cost isn't too bad.

 

[VanJoe]

Exodus like has been said, or Wayne of Superior Gunsmithing does fantastic work.

What have you had done at Superior Gunsmithing that you'd recommend? Didn't even realize they were like a mile and a half from my house.

 

[powdahound76]

Threading a barrel is cheap.

No basic hobby dude is gonna do it for much less than a smith like OTM and you have NO idea what you are getting.

Is a can really worth saving a couple bucks on threading?

 

[plinkin]

Threading a barrel is cheap.

No basic hobby dude is gonna do it for much less than a smith like OTM and you have NO idea what you are getting.

Is a can really worth saving a couple bucks on threading?

It's not for a can it's for a brake.

 

[powdahound76]

Hey guys, I've got a mp15-22 that I want to thread the barrel on. Anyone near Jacksonville FL that can thread the end for a suppressor?

Well. Here is where I got cornfused….

Simple hillbilly here. What do I know?

 

[plinkin]

Well. Here is where I got cornfused….

Simple hillbilly here. What do I know?

Lmao jkjk, I agree with the cost and risk of a home smith doing the work. I found joint force ventures charges 90 for it. Otm couldn't do it due to size restrictions.

 

[TheBigCountry]

What have you had done at Superior Gunsmithing that you'd recommend? Didn't even realize they were like a mile and a half from my house.

Nothing directly, but Wayne comes highly recommended by lots of people, and we refer most of our customers to him for work. Everyone I talk to that has used him has nothing but good things to say.