Recent content by ALShooter

This… pattern your gun then a shotkam will show you if it’s a lead issue. If you’re shooting a Benelli you will have to float the target as they shoot high.

Certified 2/1/23 Approved 8/14/23 195 days Individual

https://shop.hodgdon.com/hodgdon-retumbo/ https://shop.hodgdon.com/hodgdon-h1000/ Retumbo and H1000 1lbers in stock. Supposedly..

Hopefully he meant in the action.

Is it just rough when the lugs are riding the rails on each side? If so you can mark the rails and see where it’s interfering.

Loosen turret, dial up amount, tighten screws, turn back to zero.

I would look for excess cerakote somewhere. Something’s obviously causing interference. My 300prc premier action isn’t like that.

I just run a dehumidifier set at 55% year round in the room. Cheap insurance.

Turn 180° and take another. 👀

She’s looking promising! I had a few min after bush hogging and setup a target at 100. This was with factory hornady 225g eld match. Really was just zeroing the scope to get ready for hand loads. It was 92° so I was sitting any longer than I had to!

My T3 I purchased many years ago when beretta made available. (2006 I think) Started as a T3 Varmint. Proof 24” 308win Krg xray

Update: they received it on the 6th and I just got it back on the 15th. Not too bad!

Butane mini torch to put focused direct heat on the screws one at a time. You want to heat the screw as quick as possible while reducing transfer.

He’s gone. The number he gave is the number you need to call though. Fwiw my gmail sent their emails to my spam folder as well so be sure to check that if you ever email them.

I did the mental Olympics for sure on this, and it’s my best option right now. I don’t have the tools and don’t know anyone near me with them either. Almost ordered a barrel vise and rear entry action wrench, but buying tools to fix another’s mistake wasn’t going to sit well.