• The Shot You’ll Never Forget Giveaway - Enter To Win A Barrel From Rifle Barrel Blanks!

    Tell us about the best or most memorable shot you’ve ever taken. Contest ends June 13th and remember: subscribe for a better chance of winning!

    Join contest Subscribe

Recent content by aride4ever

  1. A

    DPMS SASS

    Re: DPMS SASS I use a gun guard for my current SASS its wide enough for optics and log enough to stash extra mags, bipod and a few other small items. It has snaps on the ends, multiple lock locations etc..
  2. A

    Gunsmithing LR308 extraction issue

    Re: LR308 extraction issue yes firing pin was removed :-) I am heading out to the range again today as im interested in knowing if the 3 C-product mags have the same issue. I ground the tab down just a bit on the mag and from what I can tell it seems that the rounds fit proper. One thing for...
  3. A

    Gunsmithing LR308 extraction issue

    Re: LR308 extraction issue just wanted to update you on the findings, I spent the good part of yesterday at the range trying different mags and ammo, it seems I have narrowed the issue down to one a specific round. Winchester bonded and a C-product mag. When I swapped either component I no...
  4. A

    Gunsmithing LR308 extraction issue

    Re: LR308 extraction issue thanks for the hit's, I am using DPMS 19RD mag's and I have had the same issue with the P-mags. It has been doing this with factory ammmo and I was hoping to get rid of it before I started reloading. One thing i have noticed is that for the most part the first...
  5. A

    Gunsmithing LR308 extraction issue

    Hi guys/gals I was hoping someone with some insight in to LR308 I have a LRT-SASS with an issue I have not experienced before with my other LR308. Whats happening is after aprox 30-40 rds I will get a failure to extract, the bolt carrier pulls the casing about 1/2 the way, the next round slides...
  6. A

    Photos .308 SLAP

    Re: .308 SLAP Hi i'm new to the forum but have lurked for a long time. if anyone is interested I can press the sabots if anyone is interested in them. I believe id need a minimum order of 100-200 to make it worth tooling. I can extrude using a variety of high temp polymers. I can also do...
See more
Top Bottom
Back
Home
Forums
Merch
Alerts