Recent content by Benchguy57

Btt Sent from my iPhone using Tapatalk

I guess a good option for a neck shot. Sent from my iPhone using Tapatalk

Doesn't that bullet just explode and ruin meat?? I've shot the 140 in my 7mm mag and just blew up. Sent from my iPhone using Tapatalk

Keep em coming in guys. And if you have any photos like Nortex did please share as well. Getting pumped, November can't get here fast enough. Sent from my iPhone using Tapatalk

Btt Sent from my iPhone using Tapatalk

Thought this would be a fun topic. What bullet will you be trusting to put meat in the freezer or a nice rack on the wall This year???? like most years I'll be using the Nosler 160 grain Accubond, hasn't let me down yet. Good luck this year and stay safe. Regards George. Sent from my...

Thanks for the help. Sent from my iPhone using Tapatalk

Unfortunately the only place I have that's close to my house is only 100 yards. :( Sent from my iPhone using Tapatalk

What's the straw method?? Thanks for the info. Sent from my iPhone using Tapatalk

Thanks. Yes the baffle is what I meant. You polished the drop portion where the plastic tip goes? Or the bottom of the unit where the powder sits?? Sent from my iPhone using Tapatalk

That was 5 fps not 15 sorry. These fat thumbs and a small phone. Lol Sent from my iPhone using Tapatalk

You're correct I did find the last two shots were within 15 fps of each other. Thanks for pointing that out. Sent from my iPhone using Tapatalk

I use both the ultra sonic and and stainless steel pins for cleaning, but drying I use my vibratory finisher. It only takes 10-15 minutes to dry them in There. My method is after they are cleaned with ultra or stainless pin wet tumbled, I wash off with cold water, wipe them off with a towel...

So I own both the charge master 1500 and uniflow. My question is when I'm loading my hunting rounds and short on time I like to use my uniflow as the charge master takes too long for each round when you're loading 75-100 rounds. The problem I'm wanting answers to is the uniflow will throw a...

So I gave this a try and have a few questions about it. If you haven't heard if this test method it's somewhere on this site. Thought it was worth a try. Basically you take a given powder and bullet combo and load one round increasing by .5-.7 grains until you're are at published max. Shoot...