bohem's latest activity
-
bohem replied to the thread Your PVA prefit experience.I think it's due to the fact that the additional stability will keep it off the edge a little longer, it's overcompensating the magnus... -
I've used 8tw forever in 6mm with 6br to 243AI, never had an issue or reduced bc with 107smk or 105vld & hybrids. I did have 2...
-
bohem replied to the thread Your PVA prefit experience.The performance improvement that I saw was only generated when shots went past 1s of flight time. At 1200yd I got much tighter...
-
bohem replied to the thread Your PVA prefit experience.Over the past year we have been tooling and testing for 8 twist 6.5mm blanks. I still like the 7.5 better for everything (just like I'm...
-
-
24 in .68 taperless tikka. runs perfect now
-
bohem replied to the thread Switch barrel build.I get that, I just don't see the point in throwing the "chinese IP stealing" comment... if LaRue was part of the concept then who's to...
-
bohem replied to the thread Who Has Coup De Grace 5.56 Pre-Fit Barrels (no barrel nuts) in stock ready to ship?.We have We, PVA, have 1 week and 2 week rush options, $200 and $100 respectively. I have 7 and 8 twist blanks on the shelf in any...
-
In reality, you probably don't want a 6.5CM built like you want a 338NM built. Two different guns with two different purposes. My very...
-
bohem replied to the thread Switch barrel build.OK? Putting a machined feature into a barrel and using a spanner wrench isn't exactly protectable IP. It's been around longer than...
-
bohem replied to the thread Your PVA prefit experience.:oops: Damn, dude.... want a work-study job testing rifles? :ROFLMAO: Awesome shooting! That reminds me of something we got from a...
-
-
Finally got a break from work to drag out my 7prc pva/cdg, 1125yds with 184gr berger/h1000@3050fps. This thing hammers and vertical is...
-
bohem replied to the thread Switch barrel build.Respectfully, I disagree. AI does not use set screws into the barrel tenon joint itself. AI uses a collapsing diameter run down using...
-
Why are you removing the scope to remove the barrel?
-
bohem replied to the thread Switch barrel build.The special cut for the WTO lug is a non-issue for any gunsmith cutting the barrels on a CNC lathe. I've done essentially what you're...
-
Good speaking with you @bohem. Badger just emailed, and they are sending me a new clamp rail, hopefully it will be here by this weekend...
