Recent content by DirtDart

  1. DirtDart

    No Seam Muzzle Brake s?

    Badger Ordnance Thruster comp.
  2. DirtDart

    300Blk At Distance

    I have good luck with 125 game changer (Sierra) over 19.5g of win 296. The barrel is a Douglas 16" 1/8 pistol gas spun by Compass lake. At my home range, you have to qually (5 consecutive shots on a 6" swinger) at 300 (actual 318Y) to shoot at the 600y line. At 300, i can hit a 6" swinger 8/10...
  3. DirtDart

    Post your sub sonic .308 loads?

    208 eldm seconds, cci 450, 8.1g of n110 out of a 16” pistol gas ar. Through an ultra 7. Quite enough for me, plenty accurate to 250y My bad, above is for 300blk. Should learn to read.
  4. DirtDart

    Maggie’s Electric hot water heater

    Op, If you can do it. Go propane tankless. Electric water heaters are power hogs. With propane, you will never worry about running out of hot water.
  5. DirtDart

    Loads for Sig 716 DMR

    Fc brass, 42.2 4064, 175 [email protected]. FGMM clone. Target is at 100y. I did change out the butt stock to a valtor sop mod and added a trigger Tec ar10 duty trigger
  6. DirtDart

    .300 Blackout

    Supers: win 296, sig brass, 125 sierra tgk, 19.5 @2.250 Subs: vvn110, Barnes brass, 208 eld, 9.7 @2.250. 9.7 of N110 shot the best but is over 1200fps. Went down to 8.1g of n110. 16” Douglas in an ar. Wolf msrp
  7. DirtDart

    Factory seconds

    Thanks Doom.
  8. DirtDart

    Factory seconds

    Doom, Thanks for the reply. That is my back up option, as I do not want to mic each bullet. I was looking for something like a case gage.
  9. DirtDart

    Factory seconds

    Gents, I bought 400 factory seconds from midway. They are 208 eld in .30cal. I would like to check the diameter on these. Is there a gage that I can drop them in to measure the diameter? I am not looking to measure the ogive or, the base to ogive, just the dimeter.
  10. DirtDart

    Match grade threaded 10/22 barrel

    Have an er shaw barrel from midway. Shoots good out to 250y. Also, had the trigger gone over by Brimstone. This is 10 at 100y
  11. DirtDart

    Upper receiver? 😳YIKES BARREL EXTENTION 😳

    This is the lug to worry about. First to left with out the ti coating.
  12. DirtDart

    Mega Billet Upper Handguard Compatibility?

    This is the seekins sp3
  13. DirtDart

    Mega Billet Upper Handguard Compatibility?

    Seekins sp3rv fits nice. This is prior to zev takeover
  14. DirtDart

    More consistent sizing?

    Mj, yes you must sort prior to sizing if you want sizing to be consistent. I know it is an extra step that most don’t do. Same goes for seating
  15. DirtDart

    More consistent sizing?

    You have to measure all cases in order for all cases to bump .001. If one is short/ long your bump will be inconsistent.
See more
Top Bottom
Back
Home
Forums
Merch
Alerts