Recent content by EasySlick

^Thanks for that info. I guess another alternative is just to go with an aftermarket bottom metal that uses AICS pattern mags. No milling needed from what I'm told.

^Thanks for that info. Yeah, it's all so confusing, lol.

^I see. Thanks.

^If the plastic T3 mag & CTR mag are both .308 it should use the same bolt stop, correct?

^Thanks.

Hey guys. I'm looking to hopefully get a definitive answer. Will the CTR bottom metal/mags work and function properly with my T3 Tactical (not T3X)? I'm looking to drop my barreled action into a CTR inletted McMillan stock. Some guys swear they've done it no problem, and some guys say "no way...

I tried to PM you but that function wasn't there when I hit your screen name. Can you please PM me? Thanks..

Are these still available?

I'll take the PRI 30mm RMR mount as discussed. Payment sent

^ Thanks for that info. Yes, mine is a .308, I'm not too keen on doing any receiver surgery on it. I guess I'll look into it further. Thanks again.

Quick question. Would my Tikka T3 Tactical barreled action drop right into a McMillan stock inletted for a CTR without any modification to the stock or receiver? I read I'd have to remove the T3's mag retaining spring/clip. I'd be using the CTR bottom metal/mags. Thanks in advance. Below is my gun.

PM sent.

^Thanks. Yeah, I had a TRG-22 (which I sold like a dope) and this gun does seem very similar. I don't know if it's the finish or the feel, but it's there. I wish I could find a McMillan or Manners to throw it in, as I'm not really a chassis guy.

I found a T3 Tactical .308 on GB the other day. I made an offer on it 5 minutes after it was listed and the guy accepted (I think I paid a bit too much). It looks like it only had maybe a box or two through it. I might throw it in a B&C Comp/Tact. stock.

Correct me if I'm wrong but, I believe the Super Varmints also have heavier barrels than the CTRs.