Recent content by Ed_

This is the solution I went with. That chunk of metal looks like a mess, but it is part of my strategy of being underestimated 🤣

The LaRue mounts do not fit. They need about 4.1-4.2” of tube to mount. I only have about 3.9”. I sent a question to ADM. Thanks!

Good question. I do not know. Right now I’m just moving back the scope with a rail extension, perhaps getting lower rings, and adding a kydex bolt-on cheek riser.

I looked at my other scopes and anything that would work better for this setup would break the $1,200 rifle + scope limit and put me in open class, and then there would always be a reason to spend more. I found one cantilever ring mount where the distance between rings and ring sizes is less...

Yes, those were the types I was looking into. This one is the lowest I’ve seen at 1.4” (others have gone as high as 1.59”). However, the distance in between rings is too large ( https://www.leupold.com/mark-ar-30mm-matte 3.46” + 0.65” + 0.65” = 4.76”) and I only have 3.9” of tube length to...

That would work! And is the cheapest solution too 👍🏻 I’ll wait a day or two before taking a saw to it… just in case.

Thanks! That’s is true, we may gain 0.5” with narrower rings. After that I run out of rail on rear. Would like to move it 2” though :(

Hi guys, I put together a small bolt rifle for NRL22 and I have a problem I hope you can help me with. The optic is a USO 3-12x and the rifle is a Savage Mark II. The issue is that the optic sits 2” further out than I need. The cantilever options I’ve seen are meant for AR’s and they elevate...