E
Featured content
1
Reaction score
210

Joined
Last seen
Viewing thread Bullets keyhole any thoughts?

Latest activity Postings Featured content About Feedback Stats

    • E
      I was at the Surgeon shop buying an action, when they were in OK, and they showed me 1086 actions actions and bottom metal that was made...
    • E
      Edds replied to the thread BAT vs Defiance?.
      I read a lot of comments about bolt clearance. There seems to be a lot of people who haven't discovered emery cloth.
    • E
      Edds replied to the thread BAT vs Defiance?.
      I have both. The first Custom action I ever bought was a BAT HR. I bought it new sight unseen based solely on what I had read about...
    • E
      Edds replied to the thread SOLD Worlds finest trimmers.
      If you sell the 6GT, give me a price for the other two.
    • E
      Edds replied to the thread 223 Magazine Question.
      Approximately .360”is what I measured mine at with dial calipers. I was hoping someone made one that was around .420”.
    • E
      Does anyone know if there are any AICS compatible 223 magazines that position the cartridge farther forward than it is in an MTD Polymer...
    • E
      Edds replied to the thread is this throat work acceptable?.
      The chambers in the link I provided may have been cut with the pilot bushing removed.
    • E
      Edds replied to the thread is this throat work acceptable?.
      There is always some Parrot that comes along and says " hows it shoot" but that doesn't change the fact that you are looking at a poor...
    • E
      Edds replied to the thread Too much neck tension.
      What are you measuring that measures .260"?
    • E
      Edds replied to the thread First bedding job.
      The best looking bedding jobs i've seen were done by longriflesinc. I would look for their videos and copy their method the best you...
    • E
      They are slightly smaller in the middle but not as much smaller as I like. You can make them however you want them to be with a few...
    • E
      If an 8.0" twist will stabilize your bullet, a 7.5" twist will work fine. If it takes a 7.5" twist to stabilize your bullet, an 8.0"...
  • Loading…
  • Loading…
  • Loading…
  • Loading…