Recent content by ezee

Check out SAS thread over muzz break @ mile high shooters supply. SAS also makes a great suppressor.

Doubt your symptoms are due to lack of blood flow. Numbness and tingling usually secondary to nerve impingement. Given that you describe issues in forearm and wrist. The cause could be from elbow upto your neck and most likely do to your position.

Agree, running 75 amax 3070 out of 8 tw 24" brux. Ballistically hangs with 243 out to about 800. Good bbl life, negligable recoil. Accurate as hell.

I bet I bought some of same 1x fired 338 NM brass as rem 7. I've got the same issue. My smith is going to try the body sizer trick with his reamer. Will see how it works.

Yep, the lady I spoke to indicated they leave the phones off hook and that someone must have mistakenly put back on. I felt they like to hook you on an web order then leave you hanging.

My experience with them has been very poor customer service. Ordered 243 brass shown in stock. Waited weeks, attempted multiple contacts email and phone. Finally got on the phone. Told ordered brass not in stock, (still shown in stock on site). Cancelled order. Won't buy from them again!

May still be limited by length to the feed ramp in a short action unless it's modified. What bullets you planning on shooting?

Re: Brake for a lightweight 338 Norma Got a SAS threaded brake on my .338 NM. Tactical set up. Doubt if its what ur after on a hunting rifle. Mine measures 0.940 at muzzle. If u want to see a pic pm me and I will email. Not set up to post pics on hide yet.

Re: Rifle barrel expansion with increasing temperature Thanks seanh. I assume the converse is true. The ID moves in and the OD moves out as tubular steel heats. So net effect on mv as this occurs?

Re: Rifle barrel expansion with increasing temperature Yep, hope his day job isn't comedy!

Re: Rifle barrel expansion with increasing temperature Same lot powder,primers,brass,fouled barrel both instances. Just curious if bore expansion/ contracture with temperature change could make a significant difference in resistance in bullet/ barrel interface causing a change in muzzle...

Re: Rifle barrel expansion with increasing temperature Got that. As stated above cartridge(powder) temps about the same in both instances room temp say 70 degrees.

Question for any engineers or those in the know, does the bore diameter of a rifle barrel increase or decrease as its temperature increases and the metal expands? Friends and I today trying to explain the drop in muzzle velocity of cartridge (same load, same rifle) of 150 fps from 90 to 35...

Re: Accurate 4350 in place of H4350 for .260 Good to know. Always loaded H-4350 for 260. Running low, picked up 8 lbs AA-4350 based on similar burn rate. Like temp stability of H-4350 though, but can't find it.

Re: How many handload for Rem 700 in .308 I'm thinking alot of manufacturers do this for liability reasons. You can't really jam the lands for instance when a bullet touches at say 2.95 in a short action in an internal or detachable mag fed rifle unless you single feed. In which case, so...