Latest activity Postings Donations Featured content Achievements About Feedback Stats
Forrest replied to the thread What did you do in the reloading room today?.I don't want to take it apart. I will go back to the hardware store and buy the hardware again and lay it out and list dimension's and...- Forrest reacted to aishooternz's post in the thread What did you do in the reloading room today? with
Like. Been a month or so of slicing up bits of wood but I'm almost finished. Just need to fill a few holes make some shelves so I can empty... - Forrest reacted to Ledzep's post in the thread What did you do in the reloading room today? with Like. PRIMING My hand hurts. A little past half way 😊
- Forrest reacted to sirhrmechanic's post in the thread What did you do in the reloading room today? with Like. Finished loading about 1100 .38 special plinkers. Came up with a plan for loading .25 acp for baby Browning. And reorganized dies and...
- Forrest replied to the thread 70-Year Old Reloads.I'm still shooting 40 sw ammo I reloaded 35 years ago and it works fine.
- Forrest replied to the thread Has rcbs gone down in QC or was always bad?.I have placed 6 orders with them directly in the last 2 years and have not had any problems with service, shipping speed or quality of...
- Forrest replied to the thread What did you do in the reloading room today?.I modified the handle on my RCBS bench priming tool. I put return springs on it to keep the handle up when you let go of it. Every time...
- Forrest reacted to Mike Casselton's post in the thread post tumble inside case expectations with Like. It's more fun if you use too much Lemishine and set the oven to 300° to dry them. BTW, that color polishes right off in the tumbler.
- Soft media does not clean the inside of the case because there is no pressure on the media. On the outside the media is under pressure...
- Forrest replied to the thread To MOS or not to MOS.I decided to send my Lone Wolf G20 long slide back to LW and have them machine it to their “Slide melt” Trijicon RMR cut. The RMR cut...
- Forrest replied to the thread To MOS or not to MOS.Still leaves me out I have G20L slide and they don't list G20 or G21 on their drop down choices.
- Forrest replied to the thread To MOS or not to MOS.I want a cut but don't want to be locked into one specific sight or small group of sights. So is there an option? Agency doesn't offer...
- Forrest replied to the thread To MOS or not to MOS.That would be my guess. Nobody else seems to offer the MOS cut.
- Forrest replied to the thread To MOS or not to MOS.From Maple Leaf site FAQ: Converting non-MOS slide to MOS footprint. Non-MOS slides cannot be safely machined to accept the Glock MOS...
- Loading…
- Loading…
- Loading…
- Loading…
- Loading…
- Loading…
