Recent content by HOGSJL

Reviving this for interest. Not conclusive, but I ran these up for a pressure test in my 300 WM. N570 ADG cases Fed 215 COAL 3.791" (to feed from a Wyatt's box)/ .093" off the lands 73gr/2651 FPS 73.5/2635 74/2662 75/2682 76/2731 77/2768 78/2794 (ejector print) Going to work around the...

Still available?

What countour is the barrel? Approx diameter at 10-12 inces from the breech? Trying to see if it will fit and not have a giant gap in the forend. Thanks

What's your separated Price? Thanks

Twist? How many rounds through it?

Figures!!!

I would be all over this if I didn't have a credit for warranty work. New ones are coming out...

Good snag! I am here at the range with my original DMR and was thinking about this one as I need to send this one back to Bushy.

Figured I would post back with my findings. My rifle, my loads, yada, yada, you know the deal... 245 Berger RP brass 85gr N570 2832 FPS es 11 Fed 215 Mag Seated deeeeep 3.743" COAL. Ran them out to .010'' off and didn't gain any velocity or accuracy. Put a chassis on and to load to the mag...

PM sent

Old thread, but may provide some newer data... Rifle: Rem 700 Barrel: Carbon Six 27" 8 twist Remage Brass: RP Bullet: Berger 245gr Primer: Fed 215mag Powder: 85gr N570 COAL: 3.743" to fit Accurate Mag Ogive: 2.906" Velocity: 2832 FPS Best Group: .6 MOA Rifle: Rem 700 Barrel: Carbon Six 27" 8...

Resurrecting this as I have picked up some of these. Anyone using them in a RUM? Plan to use N570.

PM sent

Is this molded or painted? Thanks

As stated above, let your rifle tell you what it likes. Shot a Virginia wt this year with a 180gr Berger Elite Hunter out of a 30-06. Complete pass through with typical Berger frag inside. Not far but did the job.