Recent content by JonnyD91
-
J
Thoughts on Magpul PRS Lite?
I thought that too, I checked and I have at least the amount of room that the stock kicks back. Ill at least give it a try without having to buy another tube. Don't care about the cost, I just want to shoot the damn thing. Its been a 3 month build waiting for the barrel.- JonnyD91
- Post #330
- Forum: Semi-Automatic Rifles
-
J
Thoughts on Magpul PRS Lite?
JP Enterprise Silent Capture Spring and buffer detent.- JonnyD91
- Post #328
- Forum: Semi-Automatic Rifles
-
J
Thoughts on Magpul PRS Lite?
Yeah, the issue is the buffer tube is not in far enough for the bushing and screw to rest agains the part that I circled. So i can pull the stock back and then it hits that part. I have a silent capture spring, so I don't really need the detent in there, Im going to try and remove the detent...- JonnyD91
- Post #327
- Forum: Semi-Automatic Rifles
-
J
Thoughts on Magpul PRS Lite?
it slides like an inch EDIT Maybe not an inch like 1/4 I was thinking my buffer tube wasnt screwed in enough but if i screw it in any more the detent pin wont be able to slide through the slot on the enhanced buffer tube.- JonnyD91
- Post #324
- Forum: Semi-Automatic Rifles
-
J
Thoughts on Magpul PRS Lite?
Has anyone had an issue with this stock sliding back on the buffer tube? I have the bolt tight but I was cleaning the gun today and the stock kept sliding back on the buffer tube. I am using an aero enhanced buffer tube, not sure if that would make a difference.- JonnyD91
- Post #322
- Forum: Semi-Automatic Rifles
-
J
6mm Arc Bushing size
I am looking to pick up a set of RCBS Matchmaster dies for a 6mm arc. Does anyone know the bushing size to start off with to reload their match ELD 108 heads? I tried to calculate this off the saami spec but the OD of .274 seem wrong. My dad has the caliper at his house but i forgot to give...- JonnyD91
- Thread
- Replies: 5
- Forum: Reloading Depot
