Recent content by kft101

  1. K

    SOLD WTS Nightforce ATACR 1-8 and Reptilia AUS Mount

    I’ll take the Reptilia mount and top caps. PM inbound.
  2. K

    The AI Arctic Warfare Picture Thread

    @ilikebmxbikes Also, that Wilcox RULR rail for the AI mount is super cool! Did the frogmen use that configuration and not NF 30mm rings and Wilcox RULR rail?
  3. K

    SOLD 20" AI Factory AT Lothar Walther .308 barrel and brake

    If this will fit onto an AW and the AI brake is included, I’ll take this. PM inbound.
  4. K

    Army M24 Build Thread

    For a 1990 dated M3A, I think you’d want Belgrade, MT marked Butler Creek covers?
  5. K

    The AI Arctic Warfare Picture Thread

    @ilikebmxbikes You mean one of these? 😂
  6. K

    M40 needed a Greenie

    Most probably aging, or more accurately, sun and UV light wear on the anodized finish. Edited to add info from a lot more reliable source of knowledge than my own brain cranium: “New old stock unused greenie scopes have different shades of green for different parts. It's only partially caused...
  7. K

    SOLD Larue LT840H-34-0 mount with diving board

    …
  8. K

    M40A1 repo mounts and rings

    That top simrad cap setup is the first time I’ve seen the the regular top ring half used as an undercarriage ring. Looks like that would be a lot more physically stable than relying on one small screw on either side and the scope tube itself when a heavy NV optic is clamped into the cap!
  9. K

    Optics Leupold Mark 4 ERT 6-5-20x50 M5A2

    I’ll take this if still available. Direct message inbound to the OP. Scammers don’t bother messaging me.
  10. K

    M40A1 repo mounts and rings

    Yup, looks like 3 hole (on either side, so 6 hole total) simrad caps were used in service. The TMA simrad cap I have is the same way, but not drilled all the way through. With the angled sides of both the cap pictured and the TMA cap, hard to see any but the center screw holes being used, as...
  11. K

    M40A1 repo mounts and rings

    @Frank Green Do we contact you to get in line and pay for these simrad caps?
  12. K

    Mk 13 Mod 0 stock

    Intact markings on that PSR scope = 💯🔥
  13. K

    M40A1 repo mounts and rings

    Hey all. Not to keep harping on the subject of the ring screw hole width spacing, but want to clarify my previous posts on comparisons between these group buy repro mounts and others, and in regards to simrad cap fit and compatibility. So another mount I recently acquired that was advertised as...
  14. K

    The AI Arctic Warfare Picture Thread

    @molonlave
  15. K

    Accessories Spuhr SP-5002 & SP-4003B

    I’ll take the 4003B please. PM inbound. Scammers don’t bother trying to message me.
See more
Top Bottom
Back
Home
Forums
Merch
Alerts