Recent content by M.rolen

On the last 280 AI that I built it had great accuracy at the 100 yard line fire forming factory hornady 280 rem. But I dont think the velocity would be consistent enough while fire forming to be precise at long range. Just fire form, reload, then start your long range work.

I love my 25-06 the best bullet I have found is the 115 berger but I feel the BC is low. would love to see a heavy bullet/ some new wildcats. Are any of the barrel makers doing a quarterbore with a twist faster then 10"?

I have not done it in a few years but I think you are polishing to much I believe your suppose to finish with 320 grit.

I really like that jeweling pattern. I may have to make a fixture sooner than I thought!

they allways are! thanks for the help!

thank you so i guess removing the gas tube is not required as it comes off as a unit with the barrel thank you.

Hello everyone Im trying to remove a 3.1 URX forend, I have done one before and have the tool but can not remember the exact steps I toot to do it. What I am wondering is once you take the lower rail section of do you have to remove the gas block before loosening the barrel nut? this rail does...

I have had good luck just using ATF fluid. I just take my time make small cuts normally around .030" and bush the chips from the reamer with kerosene. It may not be the most fancy way but it seems to work fine and produce a nice chamber.

That's funny, im sitting in the shop and flyleaf came on right when I read that post. Typically I listen to five finger death punch, tool, slipknot. any thing to keep people out of the shop!

The 511 was actually my first gun and it seemed pretty accurate with just the iron sight but that gun is just a safe queen now. But when I picked up the other one is when the wheels started turning! I was planning on making a base for it, bedding it, trigger, and possibly re barreling it, Im...

Hello, I picked up a remmy 511 about a year ago for 100$ its in really good shape besides a few normal wear marks in the stock, and it had a new butt plate installed but it was never ground to fit and still over sized from the stock. Up until now the rifle has just sat in the safe while I was...

I have never seen a suppressor with out threads, is there a way to order one like that or are you talking about having a smith oversize and true the existing threads on a can?

16.5" is my vote

3006 is a great round and once fired brass is pretty much free just go to the range after the opener of deer season and dig threw the garbage, Its amazing how much brass bubba will throw away, and how many shots it takes him to get sighted in.

I hate working on the xd, I watched one guy about destroy a slide trying to get the sights off. I have not attempted once since.