Recent content by MarcS

We ordered a small batch of carbon wrapped blanks from Bartlein awhile back and they'll be finished in November. They're all 30 caliber, 1.250" straight with no taper and 6" of steel at the breech end and a mix of 24" and 26" lengths. We still have both A and B extension kits available so we can...

We have some barrel makers kits here in two sizes: A for Lapua and Norma cartridges and B for 300 WM and PRC. As of now these will only be available with the purchase of a barrel job labor. We’re not stocking barrel blanks but we’ll be happy to source them or use customer supplied blanks...

I have over 200 reamers right now and I don't have a listing of them. If you need it I probably have it. If not I'll order one and if it's a very unusual cartridge that I'll likely never use again I'll charge a 50% tooling fee. Can't remember the last time I actually had to do that though. Most...

Our new shop location in Idaho is running smoother than ever before and I have the best team I've ever had working with me. We're now down to less than two weeks for barrel machine work and epoxy bedding. Machine work pricing is still what it's been for about 7 years which is $350 for a complete...

We’re cutting barrels for these on our CNC for $550. That includes all machining labor on your customer supplied parts. All of the threading and chamber work at each end of the barrel plus flat spots on the extension and lock ring for a 1-3/8” wrench. Pictured is the first one I did on my manual...

I'm getting phone calls and emails from people who are confused about this company thinking it's me. The name is almost the same and apparently someone there is also named Marc. Just FYI we have no affiliation with this company.

All of the common receivers coming out that are consistent enough to do it. Impact, Defiance Ruckus and Tenacity, Bighorn etc. They're all getting on board with this now. If I haven't cut one for the particular receiver you have then I'd need to have it here the first time. I'll save it's...

We’ve been stocking up on Bartlein barrel blanks in 6MM, 7.5 twist and 6.5MM in 8 twist. All #14 M/24 contour. We can do pre fits or hand fit to your supplied action in 7-10 business days. Additional finishing services are available but could add a couple more weeks depending on what you need...

Thank you for all of the kind words guys!

True and well said. Marc Soulie

Chad, this is why so many of us from the industry side of the community have lost respect for you over time. None of us care how many ounces your product weighs. Most of us don't really care that you were obviously exhaggerating it's weight either. That's not the point. Bursting in on this...

We've been putting in long hours and 6 day weeks for a long time so we've caught up on our back log. Buying a CNC lathe and hiring highly qualified help didn't hurt any either :) We can now get barrel machine work turned around in a week or two at the most. Cerakote and pillar bedding jobs can...

We have a new DBM we call the Bottom Dweller. It has an oversized mag box that comes down out of the stock just short of a 5 round AICS magazine. We put a beveled opening on it similar to an AR-10 and a large, one piece release tab that sweeps back close to the trigger finger. It’s cut in an M5...

We have a new self timing muzzle brake called the Kopis. It has an open top for increased gas expansion and surface area which also reduces muzzle lift, a wide bottom to reduce ground blast and the ports are angled to the rear for increased recoil reduction. The self timing jam nut on the back...

AEROMechanic sorry I didn't get back to you. I haven't been checking in here much lately. Please contact us at [email protected] or call the shop at 408-451-9850 and we'll be happy to talk about building you a left handed rifle. Marc