Recent content by Multi-Tool

bohem, I tried sending a pm, but it wasn’t allowed. I read your reply to my thread and I have some questions. Was your chamber a standard 6.5mm-06 Asquare or an A.I. or other? What twist rate and length were the barrels? Did they shoot well out to 1,000 yards? What type of shooting did...

Thanks for your insights. I’ve been considering 6.5mm-06, but thought I would ask about the 6.5 Creed to cover the bases. If you have real world experience with the 6.5mm-06, please reply or send me a PM. Thanks!

If so, what velocities did you obtain and how does it perform?

When the drill head is opened up to fit the shaft of the tri-way cutter, the retaining pieces are so far back in the drill, that it can’t be tightened on to the shaft.

I just received my Giraud tri-way trimmer last week. It works great. However, when I tried using my old corded Dewalt drill, the shaft was just a little too short for the keyless chuck on the drill to grab it. I was able to use my battery powered drill, but it would be nice if I could run this...

I found that baffling or structural steel in the path of the LABRADAR will impair function. People, including me, have tried all sorts of ideas, but the unit really needs a clear path to function properly. When I took it to a range that had wooden structure over the shooting tables, it worked...

Thanks to all for your input. I don’t like resizing rifle brass, but sometimes it has to be done. I sent some brass off for resizing a couple of years ago, but was not about to do that with Lapua brass, so I am sorting out these details of precision resizing. The feedback gives me assurance that...

Exactly, I am using the case comparator for relative measurements; not absolute measurements.

Yes, and my plan was to base the setback on cases that I knew were fired from the bolt gun. Raw data from a 10 round sample that were fired in the Rem 700, as measured using my Stoney point case comparator, has 9 cases at 3.637” and one case at 3.636”. Out of curiosity, I also measured 10...

My previous post explained issues I had with getting any appreciable setback in resizing some once-fired Lapua brass. After calling the die manufacturer, I swapped out the expander ball with one for a smaller caliber, removing the expander from process, but keeping the de-priming pin in place...

I do lubricate the inside of the case necks and of course the case body. My method for the necks is to smear some Imperial wax on a plastic brush for the caliber I am loading and run it inside the case necks. A little goes a long way, so the cases are not gooped up with lube. In the past, I...

Follow-up: I called Hornady and they told me that I could remove the expander ball and replace it with the connector from a Hornady pistol die. This would allow me to de-cap and body size in one step. I could follow this up with the mandrel step. Hopefully, this will address the issues.

One thing I could do is remove the expander and use the resizer as a body die.

I’m working on setting up my seating die to resize some once-fired Lapua brass. I use Imperial sizing wax for lube. I am not using a special resizing die; just a normal Hornady .308 resizer. I was able to set the die to the target setback between .001” and .002”. The problem I am having is that...

Hey All, Is this a good deal from Eurooptic or should consider other LRF options? I want an LRF that will range deer and steel plates out to 1,000 yards. Also, I don’t want to waste money on a product that has functional problems, so reliability is important...