Recent content by Nailz

So I finally relented and sent this back to PWS for warranty work, just got word from them that they replaced the bolt and it was headed off to QC. Good call guys on the bolt being the issue. I will say that as many issues as I seem to have had with this rifle, PWS and their customer service...

Answers below..... I swapped pins and cams, as these were the only extra parts I have, with the same results. With what I have provided above, does it still sound like it needs a new bolt? Thanks again for the help.

Thank you, I will troubleshoot and reply back as soon as I can....

Ok, I did swap out the cam pin with the same results, perhaps it's the bolt then....

It's a good question and I can't tell whether there is a burr or not to be honest... I have had the rifle since it was new, and had to send it back after about 200 rounds for problems with failures to eject. I got it back and put another 100-150 rounds through it and the tip of the firing pin...

Bump.... Bueller, Bueller?

I have a PWSmk216 and am having an issue with the BCG sticking forward after pulling the trigger during dry fire. I'm unable to pull back the charging handle in any way. The only way to release it is to slam the stock down, it will then allow me to pull the charging handle back. I can also...

Re: Tactical Shooters Equipment - What the pros use... tag

Re: What are you drinking right now!? http://www.woodinvillewhiskeyco.com/ Was the good husband and went wine tasting with the wife yesterday and this place was packed in with the 130+ wineries in the local area. This place made my day!

Re: PWS MK214 update from support: Upon test firing we discovered what was thought to be under gassing. After further investigation we found that the Barrel extension was out of time. This allowed the bolt to over rotate and hang up. We updated the buffer tube spacer and re-shot the...

Re: PWS MK214 Heard from Stacey, it's going back for warranty work, sending it out today. I will update when I get more info.

Re: PWS MK214 Been a week since I have emailed/called them and nothing.... Anyone have a better way to try and communicate with them?

Re: PWS MK214 Yeah, I have an email into them and will follow up with a call tomorrow. I did find this on their website: https://primaryweapons.com/store/pc/viewContent.asp?idpage=29 Is it semi ejecting and getting stuck? Clean the chamber, bore, and bolt thoroughly. Try a less hot ammo...

Re: PWS MK214 Yes, it does strip the next round... but since the brass is only half way ejected the next round doesn't get all the way chambered and will typically drop out when I release the mag.

Re: PWS MK214 It doesn't clear the ejection port, it gets stuck halfway out of the port so that I have to drop the mag and pull the bolt back and physically pull it out with my hand.