Recent content by plant.one

bwhahah i'm glad i clicked on this link. i needed a good laugh. thats the funniest news article i've read all week.

when i got mine - it was about 4 weeks from corrected info to stamp in hand. (called by FFL on june 4th that i could pick up my new toy)

Silencerco SParrow Form 4 on a trust Mailed: oct 31 2012 check cashed : nov 7 Form 4 arrived at FFL : june 4 2013 listening to that first quiet shot: worth the wait! there was a bit of a delay as my Schedule B had to be resubmitted (3 times) because the page number on the footers...

no that was someone else on RFC. i couldnt tell you how many people are trying to post this around or where its been mentioned.

which is amazingly why the whole petition was started - to respond to CCI's stating that if there was enough interest they would put some time and energy into the developement of a match grade round! That's where the petition is headed once it gets a good sized batch of signatures attached...

softcock, while i appreciate your bias against the 17hmr and for the 22lr but again i'll ask you - what's so wrong in wanting a better quality of ammunition to be produced for what is such a widely accepted rimfire cartridge? Repeating over and over "that its a pipe dream" just doesnt further...

½" 10 shot groups with a 17hmr? at 100 what? feet? Let me guess you went hunting for elk with it after your range session and bagged a 1 shot DRT kill at 987 yards too? no i'm not interested in any "prime waterfront" in florida. i appreciate the offer though. lol

"i dont have to trim this peice of brass.. what a dissappointment" said no reloader ive ever met.... :D

i have a older 93r17 (started out as a tupperware base model) thats sitting on a boyd's evo these days. on the whole i am VERY happy with the rifle. I seem get the best overall performance with hornady labeled vmax. My last two performer lots have been hornady's. I've had batches of...

17hmr ammo has had problems in the past with batch consistency. I know when i find a good consistent lot # i grab as much of it as i can. Usually it takes me a half dozen or more test lots to find a good one. what was being discussed was for example the comparison between standard 22 (not...

another forum i frequent a discussion was started about Match Grade 17hmr ammo. Long and short several manufacturers (including CCI the primary 17 hmr producer for several brands) were contacted about it. The reply was basically if enough interest was on the market they would likely step up to...

yes. my LR308 chambered in 7.62x51 nato has no problem with it. I dont hesitate to stuff .308 or 7.62x51 into it and run. Mine seems to like Hornady 168gr AMAX Match as its best factory load so far and will consistently shoot 3/4" 100 yd groups Its pretty happy with winchester 180g power...

Re: question on 1:8 twist AR bull barrel & reloading im doing no crimp on my 55gr vmax load for my 1:9 carbine and getting wonderful results. i'll be curious to see what happens when i go to an 20" 1:8 woa barrel and start playing with load building

Re: It doesn't get any more redneck <div class="ubbcode-block"><div class="ubbcode-header">Originally Posted By: Dr Scholl</div><div class="ubbcode-body">You could use a marble covered with a fine lapping compound to smooth out the crown a bit - just roll it around on the crown. Otherwise...

Re: My daughter and the Tec 9 bravo!