Recent content by rdracer126
-
R
M40 barrel length ?
Awesome!!! Thanks!!! This squid always understands better with pictures!!!- rdracer126
- Post #3
- Forum: Vintage Sniper Rifles
-
R
M40 barrel length ?
In the early stages of doing a clone build of late 60's M40 rifle. I have found references that call out barrel length at 24 inches. My question, Is that measurement from recoil lug to the muzzle or end of the treads to the muzzle??- rdracer126
- Thread
- Replies: 2
- Forum: Vintage Sniper Rifles
-
R
Rifle Scopes Leupold lrp 8.5-25 vs pst gen 2 5-25
JoeBUtah....have you checked your zero stop... no way it should be bottomed out with just a 20 moa rail?- rdracer126
- Post #8
- Forum: Observation & Sighting Devices
-
R
Finding a rifle builder
Wanting to have a barreled action built using a Defiance receiver and bolt with a cut rifled barrel, in 308 win. With out having to wait 6 month to a year. Any suggestions?- rdracer126
- Thread
- Replies: 44
- Forum: Bolt Action Rifles
-
R
Gunsmithing hard to clean barrel
The gun shoots good groups I recently have found that it likes 155 scenars and RE15 (1/2 - 3/4 moa, best 5 shot group was .45 at 100) My normal routine is after about 40-50 rounds I clean with a couple wet patches of hoppes then wet brush then dry patch till clean then after the next 40- 50 I...- rdracer126
- Post #14
- Forum: The Armory
-
R
Gunsmithing hard to clean barrel
I have been using Hoppes 9 coper solvent- rdracer126
- Post #5
- Forum: The Armory
-
R
Gunsmithing hard to clean barrel
I have a rem700p(26 inch 1:12) in 308. It shoots about 3/4 moa with occasional 1/2 moa groups with hand loads. The barrel is a PITA to clean. I was wandering about trying TUBB's Final Finish. Primarily to help ease barrel cleaning.I have just over 600 rounds down the tube and sounds like most...- rdracer126
- Thread
- Replies: 18
- Forum: The Armory
