Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature currently requires accessing the site using the built-in Safari browser.
Watch Out for Scammers!
We've now added a color code for all accounts. Orange accounts are new members, Blue are full members, and Green are Supporters. If you get a message about a sale from an orange account, make sure you pay attention before sending any money!
5/32 drill bit size is the tightest tolerance size for 10-32. If you have a heavily coated fastener, a Friday fastener......... it may get tight. If you have a cheap fastener it may snap. #21 isn't hard to find out in town. I'd use 5/32 for aerospace level stuff with aerospace level fasteners if...
Having to qual with a G22 at 25y, weak side/weak eye braced against a barracade, and clear a bay, weak hand non braced, was an eye opener. I've never fired weak side before.
Re: Kerosene/Jet Fuel heating question. I've run JP-5 straight in kerosene heaters long term. It smokes, ensure you have good ventilation. We didn't experience any problems mechanically.
Re: Who still has their origional GA Remington Trigger Still have the factory trigger in my 2012 700. I am happy with it so far BUT I only have @ 200 rounds through the weapon at this time.
Re: Free floating and pillar mounts on Rem 700 var I also have a SPS-V. From every forum on every sight I've read on mod'ing this stock, its not worth it. The general opinion is that by the time you inlet and reinforce to prevent flex your time and effort would have been better served with...