• Watch Out for Scammers!

    We've now added a color code for all accounts. Orange accounts are new members, Blue are full members, and Green are Supporters. If you get a message about a sale from an orange account, make sure you pay attention before sending any money!

Recent content by scissorhands

  1. S

    OCW Results (Confirm nodes)

    I can agree with that. Had a lower "node" years ago (was it because of the powder lot, bullet lot, or xxx?) years ago I remember the load being lower but my seating depth was .006" deeper than that of the target above.
  2. S

    OCW Results (Confirm nodes)

    Is that you in the video?
  3. S

    OCW Results (Confirm nodes)

    I actually ended up going with 44. I don't think you can choose wrong with any 4 of the loads. Biggest group out of the 43.7-44.6 loads went .45x and 2 of the loads went into the .35x range.
  4. S

    OCW Results (Confirm nodes)

    FWIW, Here is an OCW test with 175SMK and Varget loaded in .3 grain increments. Definitely a node from 43.7-44.6
  5. S

    So? How do I read this ladder test data?

    Its a bregara HMR 6,5 creed moor. contour 5
  6. S

    OCW / Satterlee Test Results

    Why? couldn't tell you, I agree it could have gone either way. Have yet to chronograph the loads. Saving my pennies.
  7. S

    OCW / Satterlee Test Results

    First picture, my OCW test, I picked 41gn as my load(H4350). Second pic, Testing seating depths.
  8. S

    So? How do I read this ladder test data?

    Here is part of my OCW test, you can see 40.9 and 41.2 has a pretty close POI. I adjust seating depth at the 41gn to tighten up the group.
  9. S

    So? How do I read this ladder test data?

    I don't remember the group size off the top of my head, but with the flier its around .4 MOA and with out somewhere around .26MOA
  10. S

    So? How do I read this ladder test data?

    41gn H4350 205M primer, Hornada 140gr BTHP .005 off the lands(works for my rifle) In my load development there was the node from 40.9-41.1, so I settled on the 41gn load. I can produce this group over and over again, just need to work on my shooting. LOL
  11. S

    So? How do I read this ladder test data?

    In the Hornady manual max charge is listed at 42gn with a 140 bullet. What bullet are you shooting?
  12. S

    So? How do I read this ladder test data?

    Just curious why you didn't load higher charge rates, yours seem very low. There is a node around 41
  13. S

    Developing load for 6.5 Creedmoor bolt gun

    I would go with the 41.3 or 42 group and play with seating depth
  14. S

    Developing load for 6.5 Creedmoor bolt gun

    I've had good luck with 41gn of H4350 and 140 Hornady bthp .005 off the lands in my rifle ( 5 shots)
  15. S

    Struggling to get consistent OAL to ogive

    what are you using to measure? Are you off by thousandths or more?
See more
Top Bottom
Back