Recent content by slush

There is no wiggle in the recoil pad. The one inch spacers are also tight, they are solid, they don't even spin around.

I just wanted to share an idea, I had for the KRG 10/22 LOP. I know most of us are unhappy with the LOP. I did not like all the spacers to increase the LOP. To me it looks like a loaf of bread. I bought 1" spacer, from the hardware store, for $1.50. The total LOP is at 13 3/4. I am using the...

I have a Ruger receiver with a Kidd .920 barrel and Kidd single stage trigger. When I put the barrel action in, I had to squeeze HARD to snap it into the stock. Then I had to thumb the butt of the stock on the floor to seat it, so the action screw lined up. Mine is in there like a vice. It is...

My factory receiver with the Kidd rear tang fit without any modification. The Kidd .920 barrel is free floated. What is the bag with the four plates and nuts for ???

you can install the Kidd rear tang with the cleaning hole. However, you will need to have it machined to except the anchor. I had my factory Ruger receiver machined for the anchor. I think the anchor might need to be fitted so the receiver fits level in the stock. I believe that i will have to...

Well it is getting closer at least it’s next door, hope it is not heading for Texas. Mine left for Colorado on Monday and last Wednesday it says it’s in Oregon. That is the last place I get and update. Good luck

Mine was supposed to have been delivered on Thursday. Then they said by the end of the day today. Now the tracking date says no date determined. Not sure if it’s lost.

They are saying December now. I saw it on their Facebook page. I did email them and I was told, The first run will have a Kidd anchor provision.

Dang I wish I knew that sooner. My new MeRee will be here tomorrow.

I am looking to put my CZ455 .17 HMR ,into a chassis system. I am not looking, for a high end $1000 plus chassis. So far I really like the value that you can get with a McRee chassis. I am not going to do any completions, with the rifle. I shoot prone from a bipod and have a Pig saddle , with...

So far I am looking at the Oryx or Mcree, which is in my price range

Measuring where the magazine stops are it is 1.560" long. and .366" wide. When I switch to my .22 barrel I have to use a spacer in the mag well ,to make up the difference between the .17 HMR and >22

Tell me about your MDT and can you send pIcs?

Is your stock still available? If so will it take the .17 hmr magazines?