• The Shot You’ll Never Forget Giveaway - Enter To Win A Barrel From Rifle Barrel Blanks!

    Tell us about the best or most memorable shot you’ve ever taken. Contest ends June 13th and remember: subscribe for a better chance of winning!

    Join contest Subscribe

Recent content by wapiti16b

  1. W

    Are the FN SPR enthusiasts extinct?

    I have not had this problem but I have heard if you remove the mag spring an give it a little stretch it helps.
  2. W

    Are the FN SPR enthusiasts extinct?

    The FNH TBM & Mags are GTG I use them on my SPR, I have no first hand experience with PT&G other than research that showed they do not quite fit the factory inlet on McMillan stocks but can be used with minimal modifications . The mag system I'm referring to came with the PBR and utilized a...
  3. W

    Are the FN SPR enthusiasts extinct?

    If MWGW still has the 20MOA scope mount buy it , it should fit with a tap & thread, also check out McMillan for closeout stocks in WIN SA/FNH some modification to the stock might be needed but will be minimal ( dremal and bedding compound) for PTG BM, or stick with the floor plate .The floor...
  4. W

    7mm SAW

    All barrels are different so YVMV! regardless of components and dimensions , as mentioned earlier wait for barrel break in! Excuse me for stating the obvious!
  5. W

    FN Spr value

    Now I'm so sad!
  6. W

    FN Spr value

    Dude! I could care less about the age of this thread and simply stated what MY FN Rifles are worth to me ! Mine are NOT for sale!
  7. W

    Are the FN SPR enthusiasts extinct?

    The manufacturer mark may be on the underside of the rail and they all should have a re-coil lug.
  8. W

    FN Spr value

    Mine shoot lights out so they are priceless as far as I'm concerned and since they don't make them anymore hang on to them and ENJOY! Most other precision rifles start @ 3K plus and may or may not shoot any better YMMV so in my mind if push came to shove 3K depending on the rifle and it's...
  9. W

    Are the FN SPR enthusiasts extinct?

    Near rails on both of mine along with ARC rings , no problems and swapping scopes with rings attached between rifles results in little or no shift in impact @100yds!
  10. W

    Are the FN SPR enthusiasts extinct?

    Adjustments on the FN/M70 are very easy , it is just a matter of two set nuts on the set screw to your preference. I started by the least amount possible to what I was comfortable with and tested safety by bumping the rifle butt against the floor until I was satisfied with pull and safety of...
  11. W

    Are the FN SPR enthusiasts extinct?

    The trigger on SPR&PBR are VERY adjustable and mine are just what I need, they are very crisp, however they are not a two stage if that is what you prefer and or are used to!. I prefer a two stage on my AR type rifles but NOT on my Bolt Actions but that is just me!
  12. W

    Colloidal graphite

    I use graphite in my necks in a powder media ala Sinclair, however Speedy is using colloidal graphite as a rifle barrel finishing touch after cleaning!, I'm not sure if one is better than the other but they have different application methods specific to the task at hand IMHO! I would like to...
  13. W

    Are the FN SPR enthusiasts extinct?

    Hmmmmmm!
  14. W

    Are the FN SPR enthusiasts extinct?

    A little DIY ?, and if so why the xtra longs?,reversed!
  15. W

    Scope for FN SPR...

    I went through this dilemma for the same rifle and the GEN II Razor is what I went with , if the color is more important than performance so be it!, I have an all black SPR and a stainless barrel matte black receiver PBR in a sponge job McMillan stock and I swap between the two. The GEN II has...
See more
Top Bottom
Back
Home
Forums
Merch
Alerts