Recent content by wrpicket

I did buy the Razor on sale. It's very nice, but about a pound heavier than the Minox! Now I'm just pining over if I am going to sell the Minox or move it to another rifle and sell a Vortex PST II. Obviously the former offsets the Razor's expense way more than the latter.

Nothing wrong they just aren't mind blowing or anything. The second revolution catch point thing is unusual, but not an issue.

Bump for a little help

Looking for the Hide's opinion/advice on whether I should sell my ZP5 5-25 and pick up a Gen III Razor 3-36. Use is target shooting with a 6.5CM for now, occasionally out to 1000+ yards. I like my Minox well enough, glass is amazing, turrets are meh. I'm thinking I'd like the extra power of...

I have one of these in a 22" 6.5 Creedmoor in my Aero build and have been very happy with it. Great bang for the buck at less than $500: fluted, +2 gas system, reportedly Craddock built Criterion blanks. I run mine with an Aero BCG, a KAK 9.3 oz buffer and tubb spring in a PRS Gen 3 Stock...

Did you ever figure anything specifically out on this question? I used an MPA feed lip tool to open mine up, mostly in the front, as the cartridges we going in too straight initially and then tended to push to the opposite side crashing into the chamber edge and jamming. Once I opened them up...

Yep! Thanks again Eric. Wound up getting a ZP5 for it after all. Can't wait to get home and ring it out.

Has anyone ever tried adding material to the back of an AW style mag and filing for adjustment instead of using an extended mag catch to lift it to the right feed height in an AICS tuned chassis/stock and AW cut receiver? I figure it could be tested with JB Weld and then actually welded for...