Y
Featured content
0
Reaction score
1,141

Joined
Last seen

Latest activity Postings Featured content Achievements About Feedback Stats

    • Y
      Yondering replied to the thread AR Rounds stuck in chamber.
      So, you set up a new sizing die, again without measuring shoulder bump but chasing factory dimensions instead, and then concluded SB...
    • Y
      Yondering replied to the thread AR Rounds stuck in chamber.
      Still no, not really. Sizing to the correct dimensions is needed. Small base dies and/or camming the press over are not necessarily...
    • Y
      Yondering replied to the thread 6.5 Grendel.
      Yes that’s a very slow load, as we’ve discussed several times before. You’re getting the same speed from an 18” barrel as I’m getting...
    • Y
      Yondering replied to the thread Brass Annealing Guide.
      Where did you see anyone saying they measured runout on the neck instead of the bullet?
    • Y
      Yondering replied to the thread Brass Annealing Guide.
      This only holds water if you've neck turned the brass and every single piece is a consistent thickness all the way around. If not...
    • Y
      Yondering replied to the thread 6.5 Grendel.
      I'm surprised that several of you guys are screwing around with CFE223, AA2520, etc but nobody's mentioned Lever. It's been a clear...
    • Y
      Yondering replied to the thread 6.5 Creedmoor.
      Just FYI, Superformance is a ball powder, not a flake powder. It is flattened, but still ball powder, and meters really well as one...
    • Y
      Yondering replied to the thread AR Rounds stuck in chamber.
      No, they really don't. What IS needed is to properly bump the shoulder back. I'd bet $20 that's the OP's problem, and he still has no...
    • Y
      There's a big difference between a problem you didn't know about, and a problem that doesn't exist. I'm not sure which one you're...
    • Y
      On bullet weld - I’ve been experimenting with a method of coating the case necks in wax (on the inside) to prevent this. Letting some...
    • Y
      Yondering reacted to akmike47's post in the thread Accuracy Oil???? with Like Like.
      Shouldn’t just watching any video of his make you dismiss him?
    • Y
      Yondering replied to the thread Accuracy Oil????.
      See my earlier post above. That one line, even if you heard nothing else, should be enough to tell you this guy has no idea what he's...
    • Y
      Yondering replied to the thread Accuracy Oil????.
      "It increases the density of the metal surface". :rolleyes: I couldn't stand to sit through that video so I sorta jumped around a bit...
    • Y
      And now we're on to debating the size of each other's balls. :ROFLMAO::p
    • Y
      To get a good idea of what it is like to piss on a hot suppressor why not do it on a hot exhaust pipe. The effect will be the same. A...
  • Loading…
  • Loading…
  • Loading…
  • Loading…
  • Loading…