Recent content by Yooper3402

What chassis are available with fully adjustable butt pad? Mainly wanting ability to cant for rem 700 footprint.

With the bushnell deal going on, where does the xrs rate among other mid teir optics? Other competitors I see are razor gen 2, mk5, atacr, etc. You dont hear much about the bushnells outside of the lrhs for a good budget option.

Thanks for all the good info, you dont hear much about the bushnell line anymore.

I'm looking for a new optic for my new valkyrie. I have a dmr with g2 reticle on another rifle, so I am familiar with the reticle. How does this scope rate compared to similar smaller scopes (mk5, xtr3, ATACR, etc.)?

My mistake, I thought there was mention of a michigan class in one of the podcasts.

Any update on a michigan class this year?

I will try soft seating them that way and see what results I get. It is a bartlein 5r barrel

with a good push I'm getting average of 2.21 cbto with 140 rdf, light pushes are all over the place with little consistency but hovering around 2.15. How concistent of measurements are you expecting finding the lands?

I have a 6.5 creed chambered by a good builder, but I am finding to difficult to find the lands accurately. The reamer must have been getting dull when my rifle was chambered because I am getting faint land marks on bullets when chambering factory ammo ( still shoots .5 minute groups). I have...

I just picked up a 18" SPRish upper for my rifle and looking for a good mid range scope option. Looking to spend about $500 and taking it out to 600 yards. Are there any good options in this area? thanks, jon

Here is a picture of the oal, loaded in a magazine, and a factory round loaded in chamber with marks from lands. (Rifle has 240 rounds through it already)

I will get a picture in a magazine tomorrow.Loaded factory ammo has marks on the bullet fromy what I belive to be the lands when loaded rounds are ejected. Thanks for the input

That measurement is base to tip, not base to ogive. That is why I'm concerned.

Hey guys, I've got a 6.5 creed built on a 700 action from a well known builder. For the past couple years I've been shooting factory 140 a max. Now that I'm going to start reloading, I got a Hornaday oal gauge and checking the chamber I'm getting only 2.64 COAL. Is this going to cause me any...