I recall these being out of stock for a while… I just checked and they’re in stock.
Maybe old news, maybe nobody cares, but thought I’d pass it along.
Maybe old news, maybe nobody cares, but thought I’d pass it along.
HLR .150” Recoil Lug
- Thread starter TicTacTex
- Start date
Yep seen they were in stock and ordered one. $35 shipping is fucking ridiculous but gotta have it.
Have yall measured your recoil lug? Compared to the factory one that is almost perfectly. 250, mine is .001 under to .0012 under in spots.
Last edited:
I havent
But when I run TL3 barrels on my origins using them, it’s common to get 5 shot groups well below 0.5”.
More often than not
So never felt a need to measure one.
You havin accuracy issues?
I would expect tighter for a precision surface ground part, but again, never checked mine because the rifles all just shoot
But when I run TL3 barrels on my origins using them, it’s common to get 5 shot groups well below 0.5”.
More often than not
So never felt a need to measure one.
You havin accuracy issues?
I would expect tighter for a precision surface ground part, but again, never checked mine because the rifles all just shoot
Its not going to cause a accuracy issues but I will have to size my brass. 001 more when I use that recoil lug. As a machinist i expected a little more precision out of a surface ground part. I was just wondering if other people had the same. I measure everything, in my eyes it's broke till I prove otherwise.
