• The Shot You’ll Never Forget Giveaway - Enter To Win A Barrel From Rifle Barrel Blanks!

    Tell us about the best or most memorable shot you’ve ever taken. Contest ends June 13th and remember: subscribe for a better chance of winning!

    Join contest Subscribe

Search results

Search the forum Search Articles
  1. 2clicks

    Lets talk Ladder testing

    Love the ladder test. I shoot in half grain increments low to high for instance 22, 22.5, 23, 23.5, 24 grains all in a row. Group testing I believe defeats the ladder concept. I then fine tune when I find the horizontal flat spot. Example: 75Amax with 23, 23.5. of IMR4895 groups together side by...
  2. 2clicks

    Suppressors AR-15 gas system question

    My 2 cents use an adjustable gas block watch your brass for ejector/plunger marks I can always tell when some one doesn't have their rifle tuned up properly by those marks and then its a bitch to get that blown out case head sized down again. Just my observation... I think the larue gas block is...
  3. 2clicks

    Reload recipe for m118 ammo

    I like your Style!!! Plus in my experience, it's very temp stable. Guess the Varget boys don't know that though...
  4. 2clicks

    .260 OAL question

    I forgot to mention that 2.790 oal was with 142 SMK's sub Moa at 600 with a sling. No bipod 2820-2850 fps 26 inch Bartlein barrel 1-8.5 twist. It takes 12 moa from 100-600 yards exactly with a scope. Bergers and Scenars shot well too but for the $ the 142 SMK is getting the results I need I...
  5. 2clicks

    .260 OAL question

    GAP 260 Match chamber works great for 142 SMK, 139 Scenar, and 140 Bergers just make sure to mention your using Lapua brass some reamers are kinda tight on the neck for the Lapua brass. Not so with Remington 260 & Winchester 7mm-08 brass necked down to 260 Rem. My over all loaded length is 2.790...
  6. 2clicks

    Advanced Marksmanship Does your rifle shoot like this with 75gr? PIC

    Your scenario is why they make high dollar scopes that track properly. Write down your long range zero's with the 75's and use them. I like to write them on my mags with the appropriate bullets in them that way they are quick to reference.
  7. 2clicks

    243 Win Loads

    Remington 700 sps varmint 26 inch Barrel McMillan A1 stock 87 gr VMax 36.5 grs Imr 4064 Winchester brass and primer Mag length 10 shots 600 yrds wind was getting me on some of these its a great load though good to 750 yards ran out of room there. The shots aren't centered because the Nikon...
  8. 2clicks

    Gunsmithing Stock smithing

    That's what I do 36 grit to get it going on down to 80, 150 & about 220 to finish. Then a couple Coates of eurethane usually works well to seal up any pours. Or something that's compatible with the stock material.
  9. 2clicks

    Finally!!!! I'm a little estatic!

    Nice call on the 1-10 twist! Looks like a shooter big fat barrel too well desreved, Thanks for your service!!!
  10. 2clicks

    Rifle Scopes opinions on sub $500 scopes

    Buy once cry once check out the used optics section here on the Hide you'd be better off with a used piece of decent glass. 10-14 power on the high end imho is fine 600 yards and in. You might need $800 though. All my cheap assed attempts to get by in rifle accuracy have never paid off, quite...
  11. 2clicks

    need some help with 260 rem

    142 SMK's run 2850 in my 260 26 inch Barrel using 43.3 H4350. Found my RCBS chargemaster wasn't exactly dead nuts on the powder throwing. Observing the chargemaster I noticed extra powder falling out of the tube so I dump out each charge and reweigh all loads it's a bitch but my deviation is...
  12. 2clicks

    stupid question time... reloading LC 7.62 brass to shoot out of .308 bolt rifle

    That's all I use in my bolt guns shot several hundred so far. I think I've had 1 or 2 that for some reason were tight on closing the bolt so I pulled them down and resized them. (over pressure was certain in my minds eye) Guess they didn't take the initial sizing the same way the other brass...
  13. 2clicks

    7.62 FGMM Clone Load Question

    I put it on the burn rate pressure curve body reaction when that kind of stuff happens to me. It's the only way I can justify those little shifts right or wrong. Of course it could inconsistency behind the rifle too but I'm near perfect so that can't possibly be it.
  14. 2clicks

    Rifle Scopes Recommended tool for general torquing of scope/rifle?

    I vote Borka since alls I have is a wheeler and it's not the best tool for the job mostly because my 1/4 drive socket falls off the end of the tool the detent ball sucks. Yes I called to get it replaced only to get blown off by customer service.
  15. 2clicks

    Rifle Scopes What magnification do you use when shooting at 100 yds strictly for group size?

    42X for bug holes at 100yrds in the early morning. 600 yards @ 20X for load load testing because 100 is too close IMHO for "the" most accurate load for a given High Power rifle.
  16. 2clicks

    Rifle Scopes Good QD Mount?

    I've had excellent results with 3 different Larue mounts (2 types) and yes even standard nightforce mounting and unmounting returns to Zero close enough for scope sharing amongst rifles requiring precision optics for load work up purposes and general shooting. Because yeah it's hard to come by...
  17. 2clicks

    Range Report JBM vs Shooter

    Shooter app has been dead nutz on with my 260 GAP to 600 only variance I saw was with the sight height above bore option. As I shoot irons and scope off the same rifle. All other calibers have been within 1/4 moa most likely my error.
  18. 2clicks

    Twist Rate for .308

    Love my SPS 700 Tactical Although I've changed out the stock for a McMillan and put on a muzzle break It's a bug hole shooter at 100 and at 600 wears out the steel 10' plate! I detest the promotion of Varget But 44 grains behind the 168 max in winchester brass rocks well 42.5Grs of IMR4895 works...
  19. 2clicks

    F T/R Competition 600 yard F/TR with .223

    75 Amax Imr4895 Iron sights Compass Lake AR-15 match rifle 1-7.7 twist Kreiger barrel 600 Yards five shots 223 can be a contender at 600 Yards I was trying to verify my 600 yard dope with these five shots (see photo bucket links) obviously I was off a bit but still the potential is apparent...
  20. 2clicks

    Suppressors NFA Trust What documentation is required to be in possesion of NFA item in a Trust??

    Why wouldn't you include your last name on the trust? I would think it would be a plus to do so? Mostly for those that are trustees with the same last name.
Top Bottom
Back
Home
Forums
Merch
Alerts