Search results

Search the forum Search Articles
  1. M14 Shooter

    Bulleye for 40cal ??

    Re: Bulleye for 40cal ?? I have had good luck with Winchester 231 and WST.I was using 165 grain bullets, Regards,Mike
  2. M14 Shooter

    Primers...CCI, Fed, Win, Rem????

    Re: Primers...CCI, Fed, Win, Rem???? I have also had good luck using Russian ( Wolf Primers ). I also get good results with CCI-BR-2. Regards,Mike
  3. M14 Shooter

    Has Varget Settled Down???

    Re: Has Varget Settled Down??? The reason I replied that Varget has had lot variation was due to my experience a few years back.Not only my self but a group of palma and long range shooter.We were getting 150-200 fps lower velocity than previous lots.May be quality control is better...
  4. M14 Shooter

    Has Varget Settled Down???

    Re: Has Varget Settled Down??? Most Target shooter will buy a multiple jugs of Varget from one lot.They do this so they do not have to load test with each different lot. Varget can vary quite a bit lot to lot. Regards,Mike
  5. M14 Shooter

    80 A-Max and Service Rifle

    Re: 80 A-Max and Service Rifle I was just under 2700 fps. Regards.Mike
  6. M14 Shooter

    Remington to Winchester case volume differences?

    Re: Remington to Winchester case volume differences? 23.5 Grains seems very low for a 30-06.Did you mean 43.5 as a starting load. Regards,Mike
  7. M14 Shooter

    .308 load work-up Varget/165gr BT

    Re: .308 load work-up Varget/165gr BT There is a big difference in case capacity between LC and Winchester.The LC has less case capacity than Winchester.Most re loader's will reduce charge weight when using Military and LC Brass. Regards,Mike
  8. M14 Shooter

    80 A-Max and Service Rifle

    Re: 80 A-Max and Service Rifle I run them 25 thousands off the lands.My load is 24.2 Rl-15 with a Wolf Sm Rifle Mag Primer. I found I lost accuracy if I used more than 24.5 grains of RL-15. This load shoots great out of my 1-7 Wilson Barrel WOA Upper. Regards,Mike
  9. M14 Shooter

    Not sure where the problem lies.

    Re: Not sure where the problem lies. I do not know if you tumbled your sized cases.But I would check to see if you have some corn cob stuck in your flash holes. You can put your loaded round on a flat surface to see if you have any primers not fully seated.The high ones will rock back and...
  10. M14 Shooter

    Ridge in base of once fired brass?? PICS!

    Re: Ridge in base of once fired brass?? PICS! Your range Brass was most likely fired in a semi -auto .If you have issues with brass a small base die may help . You will probably get less firings out of brass due to the brass stretching more being fired in a gas gun. Regards,Mike
  11. M14 Shooter

    Leaking Primers

    Re: Leaking Primers I had the same problem with Federal 210M in the early 1990's.Federal had me send 5 loaded round to them.I also sent them the lot #. They paid to replaced my bolt and sent me 5000 primer to replace the bad lot.Its was chemical contamination of the primer cup. IMHO I would...
View older results
Top Bottom
Back
Home
Forums
Merch
Alerts