Search results

Search the forum Search Articles
  1. redbullitt

    8.6 Blackout - where to buy the dies to form the brass from the 6.5 CM?

    That's wild. Thanks for sharing that!
  2. redbullitt

    5.56 AR15 (Slight primer cratering regardless of vel./psi)

    Looks good to me!
  3. redbullitt

    Concave Primers...?

    Have had lots of low pressure stuff leave a dented or concave primer. Agree with above about maybe that'd be the issue? Load data would be helpful
  4. redbullitt

    Subsonics..and reducing noise level

    Lots to play with here. Cfeblk and 1680 are loud. Simple as that. More gas means more loud. If you don't need to cycle action or can open and close gas you have tons of options. A faster powder, lighter bullet, longer barrel, lower velocity etc will all mean less muzzle pressure which will...
  5. redbullitt

    Savage Silencers

    Pew seemed to like the savage 22lr one I think. Haven't seen one in person yet though.
  6. redbullitt

    Accessories SilencerCo Bravo HUB 1.375-24 Direct Thread Mount 5/8-24

    I'm in for 2 of these!
  7. redbullitt

    Hodgdon's .308win subsonic titegroup load

    Pretty typical stuff for the experimentally minded folks and those afflicted by shortages lol. Works well! I'd prefer cast bullets always so it's harder to stick them in the barrel. http://gmdr.com/lever/lowveldata.htm
  8. redbullitt

    Accessories LoRa Mesh | IP Mesh MANET | for ATAK/Offgrid Encrypted Comms

    I'll be in for 4 when you get them operational. Would love 18650 battery capability.
  9. redbullitt

    Want a Tikka Arctic but cannot make a decision between 308 and 6.5 Creed

    Wonder how hard it would be to set that sight back on the barrel a bit? Any clue how the sight indexes?
  10. redbullitt

    Want a Tikka Arctic but cannot make a decision between 308 and 6.5 Creed

    Don't feel bad op... I want one of those too. The ruger scout in 308 or 223 can be modded to be similar and save a shit ton of ammo and bourbon money fwiw... but trust me it won't be enough ammo or bourbon to be the same and you'll know it every time you pull the trigger. Not that I know...
  11. redbullitt

    Recommend a place to have my glock slide cut for a RMR.

    Jagerworks here a few times. Good to go
  12. redbullitt

    265gr ACME .300blk CFE BLK

    If the coating is done well and the bullets are just a little fatter than your throat/bore they should leave your can pretty clean. Not perfect but much much cleaner than conventional cast stuff. Have run lots of similar home cast and coated bullets with great success. I have a 7 twist...
  13. redbullitt

    Primer cratering

    Lots of rem 700s seem to do that unfortunately... even sent mine to SAC and had a ptg bolt done and all kinds of goodies. Still craters everything. Annoying for sure. Not sure if it's common in the rpr. Does your rifle do it on starting loads etc?
  14. redbullitt

    Which 22lR suppressor should I get?

    Have shot on the same 16 inch rifle: gemtech outback2, sparrow, Liberty kodiak tl, and an oculus. Oculus is currently the winner by a notable bit! Run it a little wet if you want quieter and don't mind then shooting it dry. Maybe worth trying some of the cci quiet stuff. It's notably quieter...
  15. redbullitt

    Gunsmith for barrel work

    Thanks for the reply and advice! Yeah, my guy here is no longer working unfortunately and I've not found a replacement yet. On a positive note someone on reddit apparently got this done lol. Not sure if credible or not, but is the only other info I've seen. Why in the hell tacsol doesn't...
  16. redbullitt

    Smokeless Range

    Was expecting smokeless muzzleloader action lol.
  17. redbullitt

    Dillon 550 RL won’t drop consistent charges

    If stick powder is on the menu, I swap the thrower for a funnel and use charge master. Not ideal but works very well once you tune it right with the reducer in drop tube. I usually do not have to wait doe a charge of varget. Load brass and bullet and powder run handle to do it's thing and almost...
  18. redbullitt

    CZ 457 American Suppressor Ready

    Maybe helpful... I have their 457 model that comes in the manners stock. It's very forgiving on ammo for me. It does well with old and new wolf, cci standards, midas, and bunch of the ssk stuff.
  19. redbullitt

    300blk In Precision SBR Bolt Action

    I have a decently high round count on an 8 inch mini fix, cz527 wlth a 16 barrel , and an 8 inch encore in 300 blk. I mention the cz because I really like the controlled round feed for the 300blk with odd bullets etc. Accuracy has been easily moa or better with supersonic jacketed and...
  20. redbullitt

    Almost new rifle - groups spread horizontal

    It's usually my weak ass trigger control doing horizontal things lol.
Top Bottom
Back
Home
Forums
Merch
Alerts