Search results

Newbie question, but search doesn't yield anything. I have an idle 308 Remington 700 that I want to build into something on a 223 bolt face using a barrel nut setup. Is it sufficient to get a new bolt body and use the same shroud, firing pin, and spring, or should I use a complete replacement...

I have a one-piece Talley mount for an 1885. When I snug up the front screws, there is a gap of 0.050" between the mount and the receiver (measured with feeler gauges). It was worse at the receiver if I snug the rear screws. The mount selection for this rifle is very limited so I am pretty...

Abandoning my 338 Lapua ambitions and selling my Savage 112 Target Magnum, as here: Savage Arms The rifle has fewer than 20 rounds through it, shot as a break-in procedure. It appears to shoot about 3/4moa with the cheapest available S&B factory loads. I bought it new two years ago, and it is...

For sale is a Ruger Precision Rimfire in 22lr with a Vortex Diamondback Tactical 6-24x50 MRAD scope. Pretty much a turnkey rig for NRL22 Base Class if you're lucky enough to have matches near you. The rifle and scope have normal wear but both in perfect working order. The muzzle threads and...

Per the title, I would like to buy or trade for 5-10 pieces of once-fired 338 Lapua brass. Brand unimportant. For trade I have AR parts/accessories, 6.5mm/223/30cal components, some R700 stuff, scope rings, etc, etc. I whole lot of accumulated crap, actually; I'd make good deals. Thanks.

I know the combination of H4895 and 140gr bullets is less than optimal in the 6.5-284. I certainly can't find any data on it. However, I have a great deal of H4895 to burn and a partial box of 140gr A-Max's. I'd like to put together a mild load with this combination, mainly just to use as...

Does anyone have any experience with this rifle? http://cz-usa.com/product/cz-550-magnum-het-ii-338-lapua-manners-composite-stock-camo-detachable-ai-magazine/ I have been happy with a couple other CZ rifles I have, and I am a fan of the Mauser/CRF action. Thanks in advance. Dan

Friends, I have a Cooper M22 single shot I'd like to put into a McMillan A5, but McMillan doesn't inlet for that action. Can anyone recommend a gunsmith who inlets the McMillan flat-tops? Alternatively, how difficult is it to do oneself? I've never inleted a stock before, however I am a...