Search results

My buddy just called me and told me to check my Little Crow trimmer, that lines up perfectly....LOL I have it set-up a little different, more of an angle and that appears to be the cause. Thanks for everyone's help, this was driving me crazy.

This just happened after the 12th firing and them being processed, I have 50 more that have been fired but not processed and they are fine.

They all have it, but it is a bit more pronounced on some.

It has only just shown up after sizing this last batch. I still have some cases on the same number of firings, but they haven't been processed (cleaned, sized, annealed) and they don't have the line.

I checked, but that isn't it, this just popped up on the last batch of cases I processed.

Here are the details: 6.5 creedmoor Alpha brass, 12 firings, Proof barrel, the line is only on the brass that has been sized. I have 50 more that have been fired but not sized yet, they don't have the line. I inspected the sizing die (Forster) it looks perfect. These have been shoulder bumped...

Since your target is in inches, an inch would be 1/36 of a yard that equals .277777 and when you multiply that by 1000 you get 27.77777 by rounding it off you get 27.78 or 27.77777

.002 jumps are too small to see anything worthwhile, and at the end of the day are you going to chase the lands to keep it in tune? Being a .223 it would be more of a stroll after the lands :LOL:. I would jump those bullets starting at 20 thou and 40 thou off the lands with your original powder...

For barrel replacement the Magpul Armorer's Wrench has been up to the task, it also has a 1/2 torque wrench/breaker bar interface that helps aid in removal. A gunsmith buddy has busted a couple of other wrenches trying to remove that barrel nut.

Make sure your scope base is sloping towards the barrel.

Keith does a good job of explaining the voodoo.

Did your buddy get to run this ammo yet? I'm curious on its performance.

Could you post a picture of the magwell area? Is it a full size cut out or cut for the small CZ mags?

I would also be down for a brick of Rifle Match or Standard +, it's like we have become .22 junkies looking to score a fix 😄

Stumbled on this post and wondered if the op got this stock? I was looking at it also for a CZ 457 and wanted to know how you like it? Any problems inserting the mags into the magwell? If you got it please post a couple pictures, one being the magwell area with a mag inserted.

Now that people have put quite a few rounds through these, does the bolt lift and close get any easier? I handled a new one and the bolt close was stiff as hell.

580 yards 20 inches 386 yards

I duplicated the problem you are having on my own mags. The trick is to put the spring in straight, you might have to wiggle it a bit to get it to fully seat. It seems like the rear of the spring hangs up at the extended part of the follower. I hope this solution makes sense. They are kinda...

I'm looking for some magwell pictures of a KRG bravo, MPA and any other chassis or stock with the CZ mag in and out. Just trying to see how they fit in the large opening and how easy is it to hit the mag release.

@indianalex01 what height rings are you running on 22LR Savage MKII.