Search results

Sako TRG Sako S20 Tikka T3 All 3 have chrome moly hammer forged barrels that are accurate and stay that way for a long time. The 142 SMKs shoot very well as do the 153.5 Bergers. The Bergers were very consistent at 1000 yds in moderate (6-10mph) wind. Load shown below is 42.2gr N555

It is orderable, one of the key dimensions you must provide is the distance between the top of the barrel to the ARCA Swiss dovetail. For my rifle it was 1.3'.

Wanting to take advantage of the ARCA Swiss dovetail on my AXSR, I finally received the ARCA Swiss mount from Dale Poling for his Elite Iron Bipod. The mount is designed to interface with AREA 419 ARCA Swiss Clamp. The adapter has the same interface as BT Atlas Bipod no clamp version. Having...

Tipton carbon fiber, one piece design. I once had the brass end come off, I called Tipton and explained the problem, they sent me a replacement straight away.

Belief in evolution is optional, participation is not.

You only get one shot at this, so make it worthwhile. Either choice is a good one. I chose AI for personal reasons, much like choosing a reticle, it has to fulfill your requirements.

Well said

If you plan to load pistol and carbine cartridges, Dillon 550C and carbide dies if you can find them.

Glocks barrels have polygonal rifling in their barrel. Plated bullets are not recommended for use in them and may have contributed to the pressure issue you experienced. Something to consider.

TRG-22 in .260 You will not regret it.

Pick an easy caliber to reload. .308 or 6.5 cm, start there. Invest in a good quality set of standard dies, then later the more nuanced full length size bushing dies can be introduced. Stick to published data and document your loads, this will payoff in dividends. Invest in a good chronograph...

++IMR 4064 & RE15, AR-COMP & N540 work well. 175 SMK, very jump tolerant, shoots great from my M-24. I get lower SD/ES using BR-2 primers.

I shoot this bullet often (#2251), very consistent and good value for banging steel out to a mile. I seat them to a 2.825" CBTO which gives a me a .155" jump and still allows feeding from a magazine. These are very pointy bullets, so I use a Hornady Match seating die and A-Tip stem. For my...

Autotrickler V3

I own both types of systems and while each has its own merits, it comes down to personal choice. I hate cleaning guns, therefore, the piston design is my choice. Both will get dirty when suppressed, however, the piston design will always run longer simply because it's not cooking off the lube...

3.850 - Accurate Mag

Hey Vidar, The barrel nut on the RPR Magnum has 20 teeth. Chad Dixon from LRI sells the barrel nut wrenches, I just counted the teeth on that.

ditto above for Hornady 250gr A-tip, Hornady claims they are more tolerant of twist rate I'm working with the Sierra 230gr pointed Matchking #2251, Sierra recommends 1/8". I selected a 1/8" for my 300PRC, the 230gr MK did very well out to 1774 yds, only 17mils elevation with avg 2837 fps at...

The Magpul PRS3 will allow folding and locking in the folded position (the stock can be locked folded by rotating the push button). The LMT DMR 556 will allow limited folding but not locked in the folded position due to the wider SOPMOD cheeck rest will not allow the stock to fold parallel with...

Magpul PRS 3 can be installed but the length of pull will be 16.5" to start. You may have better results with the LMT DMR 556 stock, the LOP is 14.5" fully collapsed.