Search results

I recently disassembled my Sako 75 and found that the bolt stop pin had been broken. The stop had still been functioning normally. I have since read that this has been a problem for people using Sakos in the past. I have already bought a replacement pin and a spare, but I would rather find...

I'm getting ready to do my first bedding job on my Sako 75 and I'm in a bit of a quandry trying to figure out how to place the front pillar. Here's what it looks like: From the center of the action screw hole to the rear edge of the recoil lug is approximately 0.154 (I don't have the best...

Can a hot barrel produce sufficient mirage in the scope, especially at higher power, to cause significant vertical dispersion downrange? Thanks.

Can anyone point me to a diagram with the subtensions for the SWFA SS 3-9x42 with the old mil-dot reticle? I bought one from the Sample List and there was no literature included. Thanks.

While not cheap, these are still less expensive than the standard slotted Sako replacement screws. They appear to be well made and fit properly. The company is J&P Custom Products, LLC. They are out of Boise, ID. I have no affiliation with them. Hope this helps the Sako and Tikka fans. If...

What are you guys using to measure the cartridge headspace for .338LM? There doesn't seem to be much available. Thanks.

Now that I've had my TRG42 (.338) almost a year, I finally got a Vortex Razor to go with it. My questions are: 1. The Razor has 125 moa elevation adjustment. Should I be looking for a base with almost half that amount so it doesn't get wasted. Would a Near base with a 45 moa taper be...

I decided to give the SO's M14 a makeover. I like the way it looks, but I think it may be a shade too dark for this area. There is a wide variety of scenery around here, so one pattern would be pretty difficult to blend in with. Colors are standard Krylon camo, khaki, OD, and brown. Grass...