Search results

I finally broke down and went for a progressive press. Been working off single stage and turret presses for years. I have only used Type-S Match dies from Redding or Titanium Carbide dies for the 45 (also Redding). What should I be using (make and model numbers if possible) on a Dillon 650...

Don't know if this is the right forum, but since this is the 1000+ ELR forum, I figure more people here have the knowledge I need on finding a case for a very long gun. Trying to find a case for the following: AICS 338LM chassis with a 31" total barrel length (including the brake). Is is a 2.0...

Got an old one here that I am working on for a friend. Couple questions... 1. Barrell is pretty bad, where can I get a replacement or are there any others that will produce better results than the original? (thing gets hot and no rounds come out anywhere near each other on the paper) 2...

Couple questions that I cannot find the answer to... Can you change the reticle on a Nikon Buckmaster 6x18 from a BDC to something else? Can you change the reticle on a Zeiss Conquest 4.5x14 from a Rapid Z-1000 to something else? I don't mind sending into the manufacturer if needed, but I...

OK, so having some lube remain in the case neck that is not coming off. I am using standard RCBS lube. Anyone have a method of ensuring all lube, inside and out, is removed prior to priming, powder and seating?

Anyone tried this yet? I have checked the receipies but I have not seen many people do it, especially in a 24" FN SPR (1 in 12). I made a mistake of switching powders but did not switch to 175SMKs. Am I looking at pulling a bunch of bullets? Anyone give confirmation that I should be OK...

Anyone know where to get replacement or bullet drop specific turrents for a Zeiss Conquest?

OK, got a few for all of you... I have a 5R and a FN A1 SPR both in 308 and both are brand new. The 5R is said to be best at 175gr, and the SPR (also a 24" bbl) is said to be best at 168gr. Can anyone confirm this? I would like to be able to buy bulk ammo, but it sounds like they prefer...

My friend needs some work done on a 700, muzzle break install, stock work, etc. Anyone know a good gunsmith in San Jose, CA? I live in Austin and don't want to have to worry about shipping, FFLs, etc.