Search results

Who's a good gunsmith in missouri or illinois? Already been in contact with GAP and they are only wanting to do full rifle builds because of back log. Thanks Huntall

Who is a good gunsmith for bluprinting a model 7o Winchester controlled feed? Thanks Huntall

Got a MI T series free float tube and it has no torque specs. Does anyone have what it should be? Thanks Huntall

Got a MI T series free float tube and it has no torque specs. Does anyone have what it should be? Thanks Huntall

Who makes a good quality 1 piece bottom metal for a Win 70 s/a Thanks Huntall

Who all makes a detachable magazine system for a Win 70 sa in 300 WSM? Thanks Huntall

Who all makes a detachable magazine system for a Win 70 sa in 300 WSM? Thanks Huntall

is there a way to lock the turrets to keep them from getting knocked of the zero mark? how many moa adjustments does this scope have? Thanks Huntall

I have a RRA Varmint shot a few factory cheap remingtons 55grain fmjs, remington green and yellow sp, winchester sp and handloads. The handloads produced a slam fire and I was using federal match primers. I read that the Federals were to soft for the Ar rifles. Bought two 40 round boxes of...

I purchased a set of TPS-TSR 30mm rings. I also have a Sightron Slll 6x24x50 30mm tube that I was going to mount in the tps rings. When I set the scope in the rings I noticed that the rings seemed to tight for the scope and would probably leave ring markes on the scope. Has anyone had a problem...

I purchased a set of TPS-TSR 30mm rings. I also have a Sightron Slll 6x24x50 30mm tube that I was going to mount in the tps rings. When I set the scope in the rings I noticed that the rings seemed to tight for the scope and would probably leave ring markes on the scope. Has anyone had a problem...

What is the diference between 6.5 WSM and a 6.5-300WSM cartridge? Would there be any advantages in these cartridges over a 6.5-284? I thinking of getting some kind of 6.5 caliber cartridge for hunting. Thanks Huntall

Will a HS varmint win 70 s/a stock fit a wsm action with a two piece bottom metal? I have a 300wsm stainless classic with sporter weight barrel with intentions to go to a heavier barrel. The injection molded stock that came factory has to much flex to the forend for a bi-pod. I would like any...

What do I need to seal off a wood stock that has been stipped down to bare wood so not to have bleed through of the wood grain? I will be painting with Krylon. I have made one attempt with primer and then two coats with flat black but had steaking of the wood grain with shiney spots in these...

I have a RRA 16" Varmint model with the .936 diameter barrel and I would like to put a rifle length free float tube on it, preferably some type of one piece quad rail. Problem is the tube needs to fit over the EGW low profile gas block and I know from the carbine free float tube that came with...