Search results
-
C
Stainless Steel Media Testimonials
Re: Stainless Steel Media Testimonials I use lemishine, I don't think they could get any cleaner Thanks,- calbearz
- Post #590
- Forum: Reloading Depot
-
C
Stainless Steel Media Testimonials
Re: Stainless Steel Media Testimonials Some experience under my belt now. Done about 8 batches, the amount of soap seems to be important, I did one batch with low soap and the insides were not as clean. Make sure you have suds in the top when you open the tumbler, no suds = not enough soap...- calbearz
- Post #588
- Forum: Reloading Depot
-
C
Stainless Steel Media Testimonials
Re: Stainless Steel Media Testimonials Got mine today, fired up the QT12 with 20 50 BMG cases, the is range pick up brass fired in M2HB, read dirty dirty dirty! I sorted 500 rounds and my hand looked like I put on a dirt glove! 4 hours later, it looks better than new. Great stuff. Not...- calbearz
- Post #577
- Forum: Reloading Depot
-
C
Stainless Steel Media Testimonials
Re: Stainless Steel Media Testimonials Will, I would be happy to but no such App / form is included in any email I have received. Sill no reply to my question about where they get the media? Why don't the make a web site with the order form on it and post the address? You can make one...- calbearz
- Post #550
- Forum: Reloading Depot
-
C
Stainless Steel Media Testimonials
Re: Stainless Steel Media Testimonials Cool, then I'm sure they will be happy to post where they get the media? How is it above board to keep your source secret? Nothing in a twist, I just can't get any. What else should I do when I email the guy 6 times and never get a response of "ok send...- calbearz
- Post #548
- Forum: Reloading Depot
-
C
Stainless Steel Media Testimonials
Re: Stainless Steel Media Testimonials Ok, been trying to get some of this great media for months, I email the secret guy and he is out, or what he has is "spoken for". Is this vapor ware? On that note why all the secrecy? Isn't this forum a place to share info openly, not keep secrets...- calbearz
- Post #546
- Forum: Reloading Depot
-
C
6.5 vs. 7.62
Re: 6.5 vs. 7.62 Love the Swamp Donkey!!! That’s great! You are so right on, so many hunters use more gun than they need. DocGlenn I'm sure the 6.5 CM is a superb hunting round, try the 130gr Swift Scirocco II I'm shooting nice 0.50 inch groups with them leaving the barrel at 3000 fps...- calbearz
- Post #53
- Forum: Bolt Action Rifles
-
C
6.5 vs. 7.62
Re: 6.5 vs. 7.62 That’s too bad GA is out, good thing I got 400 rounds a few months ago, it reduces the available loads to only 18 GASP! vs. 6 total for the other two rounds. Still a trouncing to say the least LOL. By having 3 different rounds that basically do the same thing it reduces the...- calbearz
- Post #41
- Forum: Bolt Action Rifles
-
C
6.5 vs. 7.62
Re: 6.5 vs. 7.62 6.5 is just hands down a better choice for most of us. All rifles must balance recoil and down range effectiveness. The .260 Rem hits the sweet spot in this balancing act perfectly. If you make the bore any bigger you must go to a heavier bullet to get the same BC. 7mm...- calbearz
- Post #39
- Forum: Bolt Action Rifles
-
C
Loads for .260 /.243/ 6.5x47/6.5 Creedmoor
Re: Loads for .260 /.243/ 6.5x47/6.5 Creedmoor Good thread guys! I'm new here so lots to learn. I have a .260 Rem rifle built by GA Precision. It has a 24" M24 counter barrel made by Rock Creek and carbon fiber wrapped by ABS Inc. Lawton action with AICS mags. Nightforce 12-42x56 BR...- calbearz
- Post #93
- Forum: Reloading Depot
-
C
GAP chamber / throat length.
Re: GAP chamber / throat length. Hi Scout1 I have a GAP in .260 Rem. I have found that GAP seems to cut their chambers for VLD type bullets. I started out with 120 gr speer soft points (not VLD) and I seated to 2.800, turned my gun into a $3500 bullet puller because closing the bolt jammed...- calbearz
- Post #13
- Forum: Reloading Depot
