Search results

Nice all original Eric Reid built GAP (stamped back when 1 smith built the entire rifle) on a 700 right hand action, Badger bottom metal, Jewell trigger, Badger 20 moa rail, threaded Bartlein 23” heavy fluted MTU 1/11.25 twist barrel, McMillan A-5 stock (non adjustable) but comes with cheek pad...

I was out shooting at 980 yards today, and right at the begining of a string of shots a coyote ran right into my crosshairs. I had 1 second to range him, he was at about 800 yards. I held under 2 mils, took my shot, and saw the trace go over his back by maybe 6 inches. It scared the crap out of...

I just wanted to Say thanks to the guys at LMT. I had an overpressure issue or bad piece of brass with my 308 MWS. I bought the gun used and only fired a few shots before I had my issue. What they told me when I sent it to them was that there was a piece of brass that came appart and got caught...

I am new to some of the F1 scopes and have a question. I was unable to find my answer on the search function so please excuse this if it is a worn out topic but I have not seen it before. Is my assumption correct that the S&B 4x16x50 P4 fine LP scope comes in CM and MOA adjustments and not...

I am not sure what is going on here. I shoot a GA Precision crusader, 308 winchester, 24" barrel. Badger 20 moa base,Nightforce 5.5-22x56 NPR1. My reloads are federal case, 45 grains varget, federal match primers, 178 amax bullets, seated to 2.84. At 880 yards I am holding 12" or less depending...

I need some experienced advice. I have been working all weekend on getting my reloading station ready. I have a new T-7 press with redding comp. 308 die set. I am using 45gn varget with 178 AMAX. The unfired bullet kneck diameter is reading .338, all brass is the same. I am using a .336 neck...