Search results
-
T
Help me out
Re: Help me out Are you lubricating inside of the case mouth? What kind of lube are you using? Just a thought.- Terry Persing
- Post #8
- Forum: Reloading Depot
-
T
Gunsmithing Remington 700 .308 bore cleaning method
Re: Remington 700 .308 bore cleaning method BJ, Make sure to get all of the oil from the bore before your CCB. Patch it a couple of times with alcohol, then a dry patch and run a test. Good Luck, let me know it you try it.- Terry Persing
- Post #5
- Forum: The Armory
-
T
Gunsmithing Bedding for COLD BORE
Re: Bedding for COLD BORE Could it be from oil in the bore. Try passing a couple of patches with alcohol on them to clean out the oil, then dry patch it and then test shoot it. Let me know how it goes.- Terry Persing
- Post #11
- Forum: The Armory
-
T
Gunsmithing Objective research on Barrel Break-in procedures
Re: Objective research on Barrel Break-in procedures I've been told that when your CCB is off continually from your next group it's because of oil in the bore. You can remove this by passing a patch with alcohol through prior to going out to shoot or to the callout. (or don't put oil in your...- Terry Persing
- Post #111
- Forum: The Armory
-
T
Gunsmithing model 700 bottom metal question
Re: model 700 bottom metal question Look in Brownell"s, Item #393-210-711AB. This one is for .308. It's made by HS Precision.- Terry Persing
- Post #8
- Forum: The Armory
-
T
Gunsmithing cleaning rusty chamber
Re: cleaning rusty chamber I would try some JB Bore Bright on a patch with Kroil over a brush similar in size to the chamber to polish it up and see where that leaves you first.- Terry Persing
- Post #4
- Forum: The Armory
-
T
Gunsmithing bedding plastic stocks
Re: bedding plastic stocks Pillar bedding after a glass bedding job will be another step into repeatablitiy for you. It was a little tricky for me the first time, but is addicting and similar to glass bedding. Go for it!- Terry Persing
- Post #11
- Forum: The Armory
