Search results

Re: Which gas piston to go with XCR, POF, or PWS The XCR is the most reliable and accurate 5.56 rifle I own. I never shoot my other ARs, since I bought the XCR. You will be very pleased with a XCR.

Re: POF 308 will not eject One shot one kill has a very good suggestion. I will try it and let you know. Apparently the answer is yes the bolt holes are the same diameter on the 308 bolt and I did not pay any attention to which hole I put on top. It does change the position where the...

Re: POF 308 will not eject I took the bolt out and press a case into the face. The rim goes under the extractor and the case will go flat against the bolt face. The ejector pushes hard against the case. I have taken the entire bolt apart several times to check for any defects, but cannot...

Anyone else with a POF 308 having or had problems with the rifle not able to eject the case? Extractor works correctly, but the case is no longer ejected. The rim of the case is stuck under the extractor. The case will release from the extractor if I push it off, but it appears the ejector is...

Re: $2,500 budget for semi auto POF in 308 with a 20" fluted barrel. Shooting .5 MOA, with very mild recoil. Out to 650 yards holds sub MOA. One amazing rifle. Expensive, but amazing. I put a Bill Springfield 3 lbs trigger in it, and all I can say is WOW what a smooth trigger. It cost...

Re: How fast to push a 175 grain bullet in a gas gun? It is a POF in 308 with a 20" barrel. I know my M1A is a gas gun. I know that the M1A has to be loaded for the pressure curve of the powder and if the load is too fast using the 175 grain bullet. This will really hammer the bolt into the...

I just built an AR 10 type rifle. I have been loading and shooting 175 grain bullets in my M1A pushing them to 2550-2580 fps. What is the recommended fps speed using the same bullet, but in an AR 10 type rifle? I am assuming that all gas guns need to keep the pressure down and run the same...